Replacing the Interior Light Bulb

appliance in a garage or an unheated room without having to worry about frozen food in the freezer being spoilt. However at low ambient temperatures mentioned above, fridge contents are likely to freeze, so check and consume food in the fridge accordingly. When the ambient temperature returns to normal, you may change the setting to suit your needs.

3.Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance to more electricity. If installed next to a source of heat or freezer, maintain the following minimum side clearances:

From Cookers 50 mm (2”) From Radiators 300 mm (12”) From Freezers 25 mm (1”)

4.Make sure that sufficient room is provided around the appliance to ensure free air circulation.

Fit the two plastic wall spacers supplied with the appliance onto the condenser on the back of the

appliance by rotating 1/4 turn(See Diagram).

5.The fridge/freezer should be located on a smooth surface. The two front feet can be adjusted as required. To ensure that your appliance is standing

upright adjust the two front feet by turning clockwise or anti-clockwise,

until the product is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise.

6.Refer to cleaning and care section to prepare your appliance for use.

A special receptacle is supplied to store the mains plug during transit.

The receptacle is fixed at the back of the cabinet, near to of the compressor.

(See diagram) Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the

appliance. In the case of transportation, ensure you locate the plug in the receptacle provided to avoid transit damage.

Should the light fail to work, proceed as follows.

1.Switch off at the socket outlet and pull out the mains plug.

• You may find it useful to remove shelves for easy access.

2.Use a flat tipped screwdriver to remove the light diffuser cover by inserting the blade in each of the two recesses to prise off each side.

3.First check that the bulb hasn’t worked loose by ensuring it is screwed securely in the holder. Replace the plug and switch on. If the bulb works, replace the light cover by inserting the