Perlick Z2148 operating instructions Tapping and Cleaning Procedures, Warranty

TAPPING and CLEANING PROCEDURES

Beer Flow Control	Filling the Lines the First Time
Handle Operating	1.	Turn Beer Flow Control Handle OFF.
Positions		(See Fig. 1).
	2.	Tap fresh keg.

REPLACEMENT PARTS

1

Fig. 1	Fig. 2
OFF	ON

45°

Fig. 3

CLEAN

3.Turn Beer Flow Control Handle to CLEAN. (See Fig. 3).

4.Open the beer faucet. When solid beer appears, close the faucet. The line is full.

5.Turn Beer Flow Control Handle ON. (See Fig.2). The line is full and ready for service.

When Tapping Fresh Kegs

1.Remove coupler from empty keg.

2.Turn Beer Flow Control Handle OFF. (See Fig. 1).

2.Tap fresh keg in normal manner.

3.Turn Beer Flow Control Handle to CLEAN. position. (See Fig. 3). Wait for five seconds then turn to ON position. (See Fig. 2).

To Restart System

If beer does not flow, first turn the Flow Control Handle to OFF. (See Fig. 1). Then turn Handle to the CLEAN position. (See Fig. 3). Wait for five seconds then turn the Handle to ON position. (See Fig. 2).

To Clean

1.Untap Keg in usual manner.

2.Turn Beer Flow Control Handle OFF (See Fig. 1).

3.Attach cleaning adapter. Use Perlick’s single cleaning adapter, No. 43657, if cleaning from faucet to keg. If two or more lines are cleaned, use Perlick’s dual cleaning adapter, No. 43681.

4.Turn Beer Flow Control Handle to CLEAN and clean as usual. (See Fig. 3).

5.After flushing, turn Beer Flow Control Handle OFF and retap keg. (See Fig. 1).

6.To restore service, see above instructions.

7 8 2

3 4 5 6

9

			10
			11
Item	........Part No	Description	Cleaning Adapters
1.	.......40125	Empty keg Sensor
2.	.......43001A	Std. Yoke Assy.
3.	.......2026	Hex Nut
4.	.......2068-1	Tailpiece
5.	.......157R2P	Washer
6.	.......23682-2P	Check Valve	No. 43657	No. 43681
7.	.......31084-1	Retaining Screw
8.	.......31089-2P	“O” Ring (3 per assy.)	Single Adapter	Dual Adapter
9.	.......43061	Body w/relief valve
10.	.......31088-2P	Bottom Seal Washer
11.	.......31087-2P	Probe Washer

Warranty

Perlick products are fully guaranteed against defects in both material and workmanship for a period of one year from date of sale. Defective parts will be replaced on a no-charge basis, F.O.B. our factory, subject to our inspection. We are not responsible for parts damaged by alteration, unauthorized service, accident or abuse. All costs incident to replacement to include freight, labor and/or loss of sales are incidental to this warranty and must be borne by the user.