Kuppersbusch USA IGVS669 manual Cycle Interruption, To Interrupt a Cycle, Changing a Cycle

INTERRB%PTPNGICHANGING OR

Cycle Interruption

As a safety feature the d~shwasherwlll automatically turn itself off whenever the door is opened. However, if the door is opened quickly while in a wash or rinse cycle some water may splash out of the dishwasher. For this reason ~tis recommended that you wait 10 seconds before opening the door.

CANCELLlrNG A CYCLE

WAFPNIWG

08 Nof BULL

FULLY GtlPEN WHSELE

DISHWA,SNER XS HM

opemTraw. QUICKLY OPEN-

DOOR BPSH-

WAS HE^^;^ IS BPES;.S~ATI~N

CQULD B2ESULT IN SERIOUS

SCALDING.

I	To Interrupt a Cycle
	1. Press the on/off buMon to stop operation.
	2. Walt at least 10 seconds (or unt~lthe water
	noises stop) before opening the door,
I	TQ Wesurne ;a cycle
	Push the on/off button and close the doar.

1 Changing a Cycle

[ To change the cycle selection, press the program button of the desired cycle ONCE, The chosen cycle button (or the light above it) becomes illtr- rninateri, showing that i t has been selected,

BFJIOFF BUPTOM

			-- -
,	>	(1)
ii
1	-	-	-
Figure 23			hi

I	Cancelling a Cycle	----
	Each control panel shows whtch buttons to simulta- Figure 24
	neously push to cancel a cycle. Refer to your dish-
]I	washer to find the "Cancel Drain" buttons on your
	particular model.

1

I

I

1.Open the dishwasher door. Press the indicated buttons at the same time and hold for approximately 3 seconds.

2.Close the door. When the drain pump nolses

stop, open. the door. I f the LED d~splays'0"

.. .

then the end of the cycle has been reached and the dishwasher is reset.

3.Turn dishwasher off (push the On/Off

button.

4.The dishwasher is now ready to run a selected cycle. Add more detergent if necessary.

CANCEL CYCLE

--

i ill l i p ,

L ~ A , ~ ID,in-

Figure 25

14- ENGLISH