Setting up
•Avoid locating the appliance in direct sunlight or near heat sources such as an oven or a radiator.
•The floor should be level and even. You can compensate for an uneven floor by adjusting the adjustable feet.
•Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m³ per 8 g of R600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit, The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance.
•The appliance is set to operate within specific ambient temperature limits according to its climate rating. These temperature limits should not be exceeded. The correct climate rating for your appliance is indicated on the type plate.
SN - ST = +10 ° C to +38 °C SN – T = +10 °C to +43 °C
Operating and control elements
Temperature display
Temperature setting button Audible warning on/off button Interior light on/off button Child - proof lock
On/off button
Ventilation on/off button
Switching the appliance on and off
You are recommended to clean the appliance before switching it on for the first time (see “Cleaning”). Con-
nect the appliance to the mains – the appli- ance is on.
•To switch the appliance off : Keep ON/ OFF button pressed for 3 sec. so that the temperature display goes out.
•To switch the appliance on : Press the ON/OFF button until the Display lights up.
Setting the temperature
To reduce the temperature : Press the 
button.
To increase the temperature : Press the 
button.
•While you are entering the temperature, the set temperature will flash on the display.
•You can change the settings in increments of 1oC briefly pressing the button again.
•The electronic controls
will switch over automatically about 5 seconds after the last time you pressed the button, and the actual tempera- ture will be displayed.
•Factory temperature setting is +12oC.
If F1appears in the display, the appliance has a fault. Consult your nearest customer service point.
5