Liebherr 7082 212-02 manual Insertion into row of kitchen units

[mm]								[mm]
		631		min.						Insertion into row of kitchen units
				300 cm2			50
597	614						.			Fig. U: The appliances can be installed in a row of kitchen
						min
										units. To adapt the height of the appliance to the sur-round-
	644	1179	1		631					ing furniture a top unit 1 can be added.		GB
										A gap of at least 50 mm depth must be provided behind and
								580
H										along the entire width of this unit so as to ensure sufficient
										ventilation. The area of ventilation underneath the ceiling
										should be at least 300 cm2. The greater the area the more
			2							economically the appliance will run.
										W When installing with standard kitchen units (max. depth
										580 mm) and decor panels of max. 2 mm thickness, the
	56,5		3							appliance can be set up right next to the kitchen unit. The
										door protrudes 34 mm from the side of the kitchen unit
			4			ca				and 51 mm at the front. This enables it to be opened and
						.36				closed without difficulty.
		10								W When setting up the appliance next to a wall 4, a mini-
S			U							mum distance of 36 mm must be provided on the hinge
										side between the appliance and the wall (for the handle
										when the door is open).	3 kitchen unit side panel
										1 top unit
	I									2 refrigerator/freezer	4 wall
		8								Notes on assembling decor panels*
8	7	SW5
				14
									*	(with white appliances of height H = 1841 mm)
		10			*			18		Decor panel and frames can be attached to the door of
			17*		16					your appliance to match or contrast it to the existing kitchen
				Torx	15					colour scheme.
										The panels are available from your kitchen furniture supplier.
										The frames can be fitted later and are available from your
										dealer.
*										If you wish to fit the decor panels yourself, you will need a
					*					drill or a rechargeable screwdriver to pre-drill the retaining
13				31 B						holes. The door handles are to be replaced by the rigid han-
		5								dles included in the decor frame retrofit kit.
2										For further instructions and dimensions see the installation
		4						30		instructions included in the retrofit kit.
15		3				C		A
							32
	13	1
15
	Ta
		II				9 Torx	25
				8		25	20
		8				7
						SW5
		21					9
		20	25		180°	25	20			______________________________________________

			All types and models are subject to continuous improve
			ment and the manufacturer therefore reserves the right to
T	9	21	make modifications in the shape, equipment and technology.
		* Depending on model and options		21