Rangemaster U109200-03 manual Using the Icemaker & Water Dispenser, How the icemaker works

Using the Icemaker & Water Dispenser

Before using the Icemaker/Water Dispenser

Water supply installation

Pressure of the cold water supplied to the automatic icemaker is between 1.5 - 8.5Bar.

Installation instructions for the connection kit (to a potable/drinking water supply) are found inside the fridge.

Caution: Only an authorised person should install the water pipes and filter.

•The water tube should be of an appropriate length - usually 12 metres - and should be free of bends after being inserted into place. If the tube is too long then pressure will be reduced, therefore reducing the capacity of ice making.

•Always use potable / drinking water.

•Keep the water tube clear of heat sources.

•The water tube should be installed and tested by authorised personnel.

•When used for the first time, press and hold the cold-water button for one minute to prime the water supply. Do not press the cold-water button for any longer as this may cause the valve to heat up.

Precautions

•Never expose the water pipe to temperatures below 0°C to avoid freezing.

•Test the tubing for leaks by flushing the tube through with water, until the water runs clear.

•After the appliance has been sited into the location of your choice, make sure that the water tube is arranged so it does not incur damage through bends and kinks and is clear of any heat sources.

•A qualified appliance installer must install this appliance.

•Once the temperature inside the freezer is at -15°C ice production will begin.

•Do not over use the icemaker. If you attempt to use the ice cube button too often it will go into a shut down mode. This is perfectly normal and requires you to wait for one hour before attempting to re-use it.

•Do not use delicate or fragile glassware.

•Do not touch the ice cube outlet with your hands, or any implements to avoid injury or damage.

How the icemaker works

In every cycle 8 ice cubes are produced.

Capacity of the icemaker depends on the freezer temperature, the ambient temperature of the environment around the appliance and how often the freezer door is opened.

Do not store ice cubes, which are produced during the first batch of cubes following appliance start up, or after a prolonged break. Discard these cubes.

To ensure that the ice cube tray is filled to maximum capacity, you will need to manually arrange the ice cubes periodically.

Some ice cubes may stick together when dropped into the storage box – you will need to separate these to ensure maximum use of the icebox.

First use of the icemaker / water dispenser

Do not consume the first seven (approx) glasses of water, as there may be dust and / or impurities within the water pipes.

This will ensure that the pipes are cleared.

If in doubt, keep re-using the dispenser until the water runs clear.

Noises during ice making

The ice making process can be noisy. You may hear ice being dropped into the storage compartment. This is perfectly normal.

Storing ice for extended periods

Ice, which is stored for a long period of time, may go an opaque colour and have a strange odour. We recommend that you dispose of this ice, remove and clean the icebox. Allow the tray to dry thoroughly and cool down before replacing into the appliance to prevent ice from sticking.

Preventing ice from being made

If you do not require any ice over a prolonged period of time (i.e. during winter) you can switch off the valve between the water supply and the appliance. It is recommended that you clean the icebox, dry it carefully and replace it back into the appliance – this will prevent any odours being produced.

U109200-03 12