When Not in Use

If you are not using the appliance for an extended length of time, it is recommended that you switch oﬀ the electrical supply, empty any food out, clean the inside of the appliance and leave the door ajar. This will save energy, and also prevent a build up of stale odours inside.

Changing the Light Bulbs

Before replacing the light bulb, switch oﬀ the electricity supply and unplug the refrigerator.

•The electrical rating of the bulbs is 220~240V, 50Hz

– 25W.

•The lampholder is type E14. NEVER use bulbs over 25W.

Changing the Fresh Food Compartment Light Bulbs

1.Release the two tabs at the back of the light shield and remove the cover (Fig.5.6).

2.Turn the bulb anti-clockwise and remove, then install a new bulb.

3.Install the light shield back in the tabs in the reverse order and snap back into place.

Changing the Freezer Light Bulb

1.The freezer lamp is located centrally in the upper freezer compartment.

2.Remove the upper freezer drawer (see P11).

3.Remove the screw in the light cover.

4.Lift the light cover slightly and remove it from the appliance (Fig.5-7).

5.Rotate the bulb anti-clockwise to remove, and install a new bulb of the same rating.

6.Refit the light cover.

7.Refit the drawer.

Air Curtain Removal and Installation (only

for servicing if needed)

1.Remove the water ﬁlter.

2.Take oﬀ the fresh food light shield and unscrew the bulb.

3.Using a suitable screwdriver, remove the screws of the air curtain frame.

4.Take down the fresh food air curtain by using your hands to press down on the air curtain with a little force (Fig.5-8).

5.Reinstall the air curtain and water ﬁlter in the reverse order.

Fig.5-6

��

Fig.5-7

Fig.5-8

ArtNo.600-0024 - Removing the air curtain