Rinse Aid, Detergent, Loading the rinse aid

Fig.2-5

ArtNo.800-207 - Dispenser - Removing the rinse aid cap

Fig.2-6

ArtNo.800-208 - Dispenser -

Adjusting the rinse aid setting

Fig.2-7

ArtNo.800-209 - Dispenser - Detergent compartment

Fig.2-8	�	�
Fig.2-8

ArtNo.800-210 - Dispenser - Loading the detergent

Rinse Aid

This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door.

Loading the rinse aid

To load the rinse aid:

1.To open the dispenser, turn the cap in an anti-clockwise direction and remove (Fig.2-5).

2.Pour in the rinse aid, making sure not to overﬁll.

Regulate the amount of rinse aid used for each cycle by turning the dose adjuster (Fig.2-6), located beneath the cap, with a screwdriver.

There are 6 diﬀerent settings the normal dosage setting is 3.

IMPORTANT: Proper dosage of rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, the dosage adjuster should be turned to a higher setting. If the dishes have white streaks, turn the adjuster to a lower setting.

Detergent

Detergent speciﬁcally intended for use with dishwashers must be used. The dispenser must be reﬁlled before the start of each wash cycle following the instructions provided in the ‘Programme overview’. The detergent dispenser is located on the inside panel of the door.

Loading the detergent

To load the detergent:

1.Open the cover on the dispenser by pressing the button (Fig.2-7).

2.Pour the detergent for the wash cycle into compartment ‘A’ (Fig.2-8).

3.Pour the detergent for the prewash cycle into compartment ‘B’ (Fig.2-8).

4.After the detergent has been placed in the dispenser, close the cover and press down until it clicks in place.

Note: To allow the cover to close properly, remove any excess detergent from the edges of the dispenser.

DO NOT use 3-in-1 or similar tablets when Rapid Wash and Soak programmes are selected.