Perlick R24N, R24S specifications Door Switching Instructions Single Door Refrigerator, Step

Door Switching Instructions – Single Door Refrigerator

Tools Required

■Large Flathead Screwdriver.

■Regular Philips-head screwdriver.

■Small Philips-head screwdriver

Left Hinged Door

Units are available from factory mounted left or right. Workboard units are avail-

HINGE

BRACKET

CLOSING INSERT

STEP 4:

Remove bottom hinge bracket to allow you to remove the door closing insert. Immediately replace hinge bracket.

	HINGE
STEP 5:	BRACKET

able with left mounting only. All doors may be changed by customer.

Remove top hinge bracket to allow assembly of door closing insert removed in step 4. reassemble hinge to door after installing the closing insert.

Operations to Perform

Operation Notes

STEP 1		NOTE: Changing
		the door mount is
STEP 5	STEP 2
		not advised if you
		have a custom
		wood overlay.
		This may result in
		having a handle
		in an undesirable
		location.
STEP 4	STEP 3

STEP 1: Remove top hinge pin from assembly. HINGE PIN Carefully lift and tilt out door assembly from the unit and set aside.

NOTE 1:

NOTE 4

Lower left hinge bracket rotates 180° and becomes upper right hinge bracket.

NOTE 2 & 3:

NOTE 1

NOTE 2

NOTE 3

NOTE 5

STEP 2:

Carefully remove hole plugs on right side of unit. be careful not to

scratch unit. Top and bottom plugs HOLE must be removed. Do not discard. PLUGS

Top left hinge bracket rotates 180° and becomes bottom right hinge bracket.

Bottom hinge pin and door closing insert assemble to bottom right hinge bracket.

HINGE	DOOR
	HINGE
BRACKET
	BRACKET
CLOSING	UNIT
INSERT
	HINGE
DOOR
CLOSING	BRACKET
INSERT
BOTTOM	HINGE
HINGE PIN
	PIN

STEP 3:

Remove top and bottom hinge brackets from unit. Then remove door closing insert and hinge pin from bottom hinge bracket. See door bottom hinge assembly detail.

NOTE 4: The hole plugs removed earlier are to be inserted into the vacant left door mounting holes. Do not hit with hammer or damage may occur. Use hammer handle or wood block to push plugs into holes.

NOTE 5:

Door bottom on right mounted version was door top on left mounted version. Before attempting to re-mount door verify that: (1) The door handle will be on the outside of door. (2) The door closing inserts are on the bottom. (3) All screws are hand tightened, over tightening will dam- age the unit.

8300 West Good Hope Road • Milwaukee, WI 53223 • Phone 414-353-7060 • Fax 414-353-7069

Toll Free 800-558-5592 • E-Mail: Perlick@Perlick.com • www.Perlick.com

Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.	Form No. Z2288
	Rev. 8.22.06