Installing Your Freezer, Unpacking Your Freezer

Installing Your Freezer

Unpacking Your Freezer

1.Remove all packaging material. This includes the foam base and all adhesive tapes holding the freezer accessoriesinside and outside.

2.Inspect and remove any remains of packing, tape or printed materials before powering on the freezer.

Adjusting Your Freezer

•Your freezer is designed for freestanding installation only. It should not be recessed or built-in.

•Place the freezer on a floor,which is strong enough to support it fully loaded.

•When moving the freezer, never tilt it more than 45-degree angle. This could damage the compressor and the sealed system.

•If the freezer is tilted let it stand in an upright position for at least 24 hours prior to plugging. This is to allow the refrigerant to settle.

Proper Air Circulation

• To assure your freezer works at the maximum efficiency it was designed for you should install it in a location where there is proper air circulation, plumbing and electrical connections.

• The following are recommended clearances around the deep freezer:

Sides	100mm
Top	100mm
Back	100mm