Electrical Connection

EN	If your appliance is supplied with a 13 amp. fused plug

	it can be plugged into a 13 amp socket for immediate
	use. Before using the appliance please read the
	instruction below.
		WARNING: THIS APPLIANCE MUST BE

	EARTHED.
	THE FOLLOWING OPERATIONS SHOULD BE
	CARRIED OUT BY A QUALIFIED ELECTRICIAN.
	Replacing the fuse:
	When replacing a faulty fuse, a 13 amp ASTA
	approved fuse to BS 1362 should always be used, and
	the fuse cover re-fitted. If the fuse cover is lost, the
	plug must not be used until a replacement is obtained.

As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminal in your plug, proceed as follows:

connect Green & Yellow wire to terminal market “E” or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red.

Connect Blue wire to terminal marked “N” or coloured Black.

If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board.

If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use.

Replacemente fuse covers:

If a replacement fuse cover is fitted, it must be of the correct colours as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with the following code:

Removing the plug:

Ifyour appliance has a non-rewireable moulded plug and you should wish to remove it to re-route the mains cable through partitions, units etc., please esure that either:

- the plug is replaced by a fused 13 amp re-wireable plug bearing the BSI mark of approval

-or:

-the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS

5733) which is accessible without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket.

BLUE		“NEUTRAL” (“N”)
BROWN		“LIVE” (“L”)
GREEN AND YELLOW		“EARTH” (“E”) or

Instruction for connecting cable to an altenative plug:

Important: the wires in the mains lead are coloured in accordance with the following code:

Green & Yellow	- Earth
Blue	- Neutral
Brown	- Live

CAUTION:

-Once the appliance has been installed, the electrical plug and socket should remain accessible.

-The Company shall not be held responsible for any incidents that occur if these regulations are not observed.

Disposing of the appliance:

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.