Indesit DVG 622 Detergent and Rinse Aid, Loading the detergent, Rinse aid, Loading the Rinse Aid

Page 6

Detergent and Rinse Aid ....

Detergent

Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel of the door.

Loading the detergent

To open lid "A", press button "B". The cleaning detergent should be introduced into the two containers "C"and "D" up to the rim.

After pouring in the detergent, replace the lid, pressing down until it clicks.

Dishwasher detergent in tablets is now available on the market, in which case you should place one tablet into container "D" and replace the lid.

BD C

A

Notice: To facilitate closing the cover, remove any excess detergent on the edges of the dispenser.

The rinse aid.

This product makes dishes sparkle more as it improves their drying. The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "T" flashes.

Loading the Rinse Aid

To open the dispenser, turn the "C" cap in the anti- clockwise direction and then pour in the rinse aid, making sure not to overfill. The amount of rinse aid used for each cycle can be regulated by turning the "F" dose adjustor, located beneath the "C" cap, with a screwdriver. There are 6 different settings; the normal dosage setting is 4.

FC

Important:

Proper dosage of the rinse aid improves drying.

If drops of water remain on the dishes or spotting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting.

Warning

Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one.

If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the formation of white streaks on your dishes or on the interior of the appliance.

Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container.

If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2. In any case, please read the manufacturer's instructions on the packet.

If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number of cycles.

GB

4

Image 6
Contents DVG Page Safety Is a Good Habit to Get Into Close-up View control panelTechnical characteristics Close-up View InteriorSalt Loading the detergent Detergent and Rinse AidDetergent Rinse aidHow to adjust the Upper rack How to Use the Lower RackHow to Use the Upper Rack Loading the DishwasherTurning on the Appliance Wash Cycle Table \FOHGHVFULSWLRQHow to Keep Your Dishwasher in Shape Energy Saving TipsFilter assembly Cleaning and Special MaintenanceTroubleshooting Cleaning the sprayer armsInstallation Replacing the fuse Replacemente fuse coversHow to connect an alternative plug Removing the plugPage Page Merloni Elettrodomestici