CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: To reduce the risk of electric shock,
do not remove cover (or back). No user-serviceable parts inside.
Refer servicing to qualified service personnel.
CAUTION: To prevent electric shock, do not use this (polarized) plug with
an extension cord, receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
1. | Read these instructions. |
2. | Keep these instructions. |
3. | Heed all warnings. |
4. | Follow all instructions. |
5. | Do not use this apparatus near |
water. |
6. | Clean only with a dry cloth. |
7. | Do not block any ventilation |
openings. Install in accordance with |
the manufacturer’s instructions. |
8. | Do not install near any heat |
sources such as radiators, heat |
registers, stoves or other apparatus |
(including amplifiers) that produce |
heat. |
9. | Do not defeat the safety purpose of |
the polarized or grounding-type plug. |
A polarized plug has two blades with |
one wider than the other. A ground- |
ing-type plug has two blades and a |
third grounding prong. The wide |
blade or the third prong are |
provided for your safety. If the |
provided plug does not fit into your |
outlet, consult an electrician for |
replacement of the obsolete outlet. |
13.Unplug this apparatus during light- ning storms or when unused for long periods of time.
14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is dam- aged, liquid has been spilled or objects have fallen into the appara- tus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15.Do not use attachments not recommended by the product manufacturer, as they may cause hazards.
16.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended
to operate from battery power, or other sources, refer to the operating instructions.
17.If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article
810of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and require- ments for the grounding electrode. See Figure A.
18.An outside antenna system should not be located in the vicinity of over- head power lines or other electric light or power circuits, or where it can fall into such power lines or cir- cuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.
19.Do not overload wall outlets, extension cords, or integral conven- ience receptacles, as this can result in a risk of fire or electric shock.
20.Never push objects of any kind
into this product through openings, as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.
21.Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
22.When replacement parts are required, be sure the service tech- nician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitu- tions may result in fire, electric shock or other hazards.
23.Upon completion of any service or repairs to this product, ask the serv- ice technician to perform safety checks to determine that the product is in proper operating condition.
24.The product should be mounted to a wall or ceiling only as recom- mended by the manufacturer.
10. | Protect the power cord from being |
walked on or pinched, particularly at |
plugs, convenience receptacles and |
the point where they exit from the |
apparatus. |
11. | Only use attachments/accessories |
specified by the manufacturer. |
12. | Use only with the cart, stand, tri- |
pod, bracket or table specified by the manufacturer or sold with
the apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury from tip-over.
Figure A. |
Example of Antenna Grounding as |
per National Electrical Code |
ANSI/NFPA 70 |
Antenna Lead-In Wire
Ground Clamp
Antenna Discharge Unit (NEC Section 810-20)
Grounding Conductors (NEC Section 810-21)
Electric Service Equipment
Ground Clamps
Power Service Grounding Electrode System
(NEC Art. 250, Part H)
