Connecting the gas supply, Electrial connection

removal or servicing. Connection of the appliance to the gas mains or liquid gas must be carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable to the type of gas to be used. If not, follow the instructions indicated in the paragraph headed “Adaptation to different gas types”. On some models the gas supply can be connected on the left or on the right, as necessary; to change the connection, reverse the position of the hose holder with that of the cap and replace the gasket (supplied with the appliance). In the case of connection to liquid gas, by tank, use pressure regulators that conform to the regulation in force. The gas supply must be connected to the left of the appliance. Be sure that the hose does not pass through the rear of the cooker touching hot parts.

HOT PARTS

Important: make sure the supply pressure conforms with the values shown in the table entitled “Caracteristics of the burners and nozzles”. When the cooker is installed between cabinets (recessed), the gas connection must be effected by an approved flexible hose with bayonet fitting (BS 669 Current Edition). The gas inlet for the cookers is a threaded G 1/2 gas female fitting.

Connecting the gas supply

To make the connection, a flexible hose should be used corresponding to the current gas regulations which are:

•the hose must never be at any point in its lenght in contact with the “hot” parts of the cooker;

•the hose must never be longer than 1,5 metre;

•the hose must not be subject to any tension or torsional stress and it must not have any excessively narrow curves or bottlenecks;

•the hose must be easy to inspect along its entire length to check its condition;

•the hose must always be in good condition, never attempt to repair.

Important: the installation must comply with gas safety (installation and use) regulations 1984. In all cases for the above, by low, a qualified, corgi approved engineer must be called for installation.

Electrial connection

Power supply voltage and frequency: 220-240V a.c. 50/ 60 Hz.

Note: the supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature.The cable must be routed away from the rear vents. Should you require it, you may use a longer cable, however, you must ensure that the cable supplied with the appliance is replaced by one of the same specifications in accordance with current standards and legislation.

Your appliance is supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below.

WARNING - THIS APPLIANCE MUST BE EARTHED. THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re- fitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

Removing the plug:

If your appliance has a non-rewireable moulded plug and you should wish to remove it to add a cable extension or to re-route the mains cable through partitions, units etc., please ensure that either:

•the plug is replaced by a fused 13 amp re-wireable plug bearing the BSI mark of approval.

or:

•the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance.

Please note: for appliances with a rating greater than 13

amp (eg: electric hob, double ovens and freestanding electric cookers etc.) the mains cable must be wired into a cooker output point with a rating of 45 amp. In this case the cable is not supplied.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket. Instructions for connecting cable to an alternative plug:

Important: the wires in the mains lead are coloured in accordance with the following code:

Green & Yellow	- Earth
Blue	- Neutral
Brown	- Live

If the colours of the wires in the mains lead do not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked “E” or or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red. Connect Blue wire to terminal marked “N” or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A 15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with the following code:

K6G210/G, K6G21/G specifications

Indesit K6G21/G and K6G210/G are dynamic cooking appliances designed for efficiency and versatility in the kitchen. Both models feature a sleek design that seamlessly integrates into any kitchen decor, offering both aesthetic appeal and functional practicality.

One of the standout features of the Indesit K6G21/G and K6G210/G is their 4-burner gas cooktop. This allows for simultaneous cooking on multiple pots and pans, making it an excellent choice for those who enjoy preparing elaborate meals. Each burner is designed with varying power levels, catering to different cooking needs, from simmering sauces to boiling water rapidly.

Additionally, these models are equipped with a built-in gas oven, providing ample cooking space for baking, roasting, and grilling. The oven's gas function ensures quick heat-up times and even cooking results, making meal preparation more efficient. With the added convenience of adjustable temperature settings, chefs can achieve precise cooking results.

The Indesit K6G21/G and K6G210/G also focus on safety features, designed to protect users during operation. A flame failure device is included, which automatically cuts off the gas supply if the flame goes out. This feature is particularly important for households with children or for those who prioritize safety in the kitchen.

In terms of cleaning, both models feature removable oven racks and a smooth enamel interior that simplifies maintenance. The design is intended to minimize food residue buildup, making it easier to keep the oven clean and hygienic.

Energy efficiency is another highlight of the Indesit K6G21/G and K6G210/G. With energy-saving features, users can cook their meals while being mindful of their environmental impact and household energy consumption.

For those looking for a reliable, stylish, and feature-rich cooking appliance, the Indesit K6G21/G and K6G210/G represent an attractive option. With their robust construction, thoughtful features, and efficient designs, they are ideal for both everyday cooking and special occasions. Whether you're a novice cook or a seasoned chef, these appliances can enhance your culinary experience while offering modern solutions to traditional cooking methods.