Installation Instructions for built-in

The following instructions are directed at the qualified installer so that the installation and maintenance proceedures may be followed in the most professional and expert manner possible.

Important: Unplug the electrical connection before performing any maintenance or regulation upkeep work.

Installation of built-in stove tops

The electric hobs are prepared with protection degree against excessive heating ofY type, it is therefore possible to instal them next to furniture which is higher than the working board. For a correct installation of the cooking top the following precautions must be followed:

a)The hob may be located in a kitchen, a kitonen/diner or bed sitting room, but no in a bathroom or shower room.

b)The hoods must be installed according to the requirements in the hood handbook.

c)The dimensions of the cutout for the appliance must be those indicated in the figure. Clamps are provided to fasten the cooktop to counters measuring from 20 to 40 mm in thickness. To fasten the cooktop securely, it is recommended that all the clamps be used.

N.B: Use the clamps contained in the "accessory kit."

d)In case a wooden panel should be fitted under the top for insulation, it will have be fitted at a minimum distance of 20 mm from the inferior part of the top.

Important: When installing the hob on a built-in oven, the oven should be placed on two wooden strips; in the case of a joining cabinet surface, remember to leave a space of at least 45 x 560 mm at the back.

.	45	mm.
mm		mm.
560

When installing on a built-in oven without forced ventilation, ensure that there are air inlets and outlets for ventilating the interior of the cabinet adequately. Assembly examples are given in figs.

		555 mm.

	.
55	mm		mm	.
	mm

		475

Fastening Clamps - Assembly Diagram

20	30
Clamp Position for	Clamp Position for
H=20mm top	H=30mm top
	Front

	40
Clamp Position for
H=40mm top	Back

Electrical connection for electric hob

The following installation procedure must be carried out by a qualified electrician.

Important: the cooker must be connected to the mains by a switched (double pole) cooker outlet correctly fused with a capacity appropriate to that shown on the hob Rating Plate. All electrical wiring from the consumer unit to the appliance, via the switched double pole cooker outlet, must be of an acceptable type and current rating as above. The supply cord, type H05 VV-F 3x2.5mm2, must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature. The electrical installation must comply with the IEE Regulations, Building Regulation & local By-Lays.

WARNING: THIS APPLIANCE MUST BE EARTHED. In the case of installation over a built-in electric oven the electrical hook-up of the stove top and that of the oven should be separate, for reasons of safety as well as for ease of eventual removal of the oven.

Supply cable installation

The electrcic hobs are supplied without cable. Use a cable:

H05 VV-F 3x2.5mm2

•Open the terminal box by removing the "V" screw and taking off the cover.

•The wires in the mains lead are coloured in accordance