Instalation, Installation of Built-in Ovens

Instalation

The appliance must be installed only by a qualified person in compliance with the instructions provided. The manufacturer declines all responsibility for improper installation which may harm persons and animals and damage property.

Important: The power supply to the appliance must be cut off before any adjustments or maintenance work is done on it.

Installation of Built-in Ovens

In order to ensure that the built-in appliance functions prop- erly, the cabinet containing it must be appropriate. The figure below gives the dimensions of the cut-out for instal- lation under the counter or in a wall cabinet unit.

The panels of the adjacent cabinets must be made of heat- resistant material. In particular, cabinets with a veneer ex- terior must be assembled with glues which can withstand temperatures of up to 100 °C.

In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once it has been installed.

All parts which ensure the safe operation of the appliance must be removable only with the aid of a tool.

To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the 4 wooden screws into the 4 holes located on the perimeter of the frame.

595 mm.	23 mm.
595 mm.	567 mm.
	5 mm.

595	mm.		.
		545	mm
		545
	.
	mm
24

		.
45	mm
	558	mm.
		mm.

593 mm.

The panels of the adjacent cabinets must be made of heat resistant material. In particular, cabinets with a veneer exterior must be assembled with glues able to withstand temperatures of up to 100°C.

Once the appliance has been installed, the electrical parts

N.B.: Installation in compliance with the consumption declaration

	.
45	mm
	.
min

mm.595			23 mm.	.mm567			585-575mm.	595mm.		.
					558				45	mm
					558	mm.			45	.
						mm.				min
			5 mm.
	595	mm.		.
			545	mm
			545
		.
		mm
	24

In order to ensure adequate ventilation, the back panel of the cabinet unit must be removed. Installing the oven so that it rests on two strips of wood is preferable. If the oven rests on a continuous, flat surface, there must be an ap- erture of at least 45 x 560 mm.

.	45	mm.
mm		mm.
560

must be totally protected from all contact, according to current safety regulations.

All protecting parts should be firmly fixed and should require the use of a tool for removal.

When installing below a built-in hob, ensure that there are air inlets and outlets for ventilating the interior of the cabinet adequately. Assembly examples are given in figs.

Electrical connection

Ovens with a three-pole power supply cable are designed to operate with alternated current at the supply frequency and voltage indicated on the data plate (at the bottom of the oven dashboard). The earthing conductor of the cable is the yellow-green conductor.

Two types of connection are provided:

Connection n° 1

Connecting the power supply cable to the mains.

Fit a normalized plug to the cable, which corresponds to the load indicated on the data plate; if the cooker is connected directly to the mains, an omnipolar circuit- breaker with a minimum opening of 3 mm between the contacts, suitable for the load indicated and complying with current directives, must be installed between the appliance and the mains (the earthing wire must not be