Care and maintenance
| Switching the appliance off | |
GB | ||
Disconnect your appliance from the electricity supply | ||
| before carrying out any work on it. | |
|
Cleaning the appliance
!Never use steam cleaners or pressure cleaners on the appliance.
• Clean the glass part of the oven door using a sponge and a
• The stainless steel or
• The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.
• The accessories can be washed like everyday crockery, and are even dishwasher safe.
• Dirt and grease should be removed from the control panel using a
• Stainless steel can be marked by hard water that has been left on the surface for a long time, or by aggressive detergents containing phosphorus. After cleaning, rinse well and dry thoroughly. Any remaining drops of water should also be dried.
Inspecting the oven seals
Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest After- sales Service Centre. We recommend that the oven is not used until the seals have been replaced.
Replacing the oven light bulb
1. After disconnecting the oven from the electricity mains, remove the glass lid covering the lamp socket (see figure).
2. Remove the light bulb and replace it with a similar one: voltage 230 V, wattage 25 W, cap E 14.
3.Replace the lid and reconnect the oven to the electricity supply.
Cleaning the glass ceramic hob
!Do not use abrasive or corrosive detergents (for example, products in spray cans for cleaning barbecues and ovens), stain removers,
•It is usually sufficient simply to wash the hob using a damp sponge and dry it with absorbent kitchen roll.
•If the hob is particularly dirty, rub it with a special glass ceramic cleaning product, then rinse well and dry thoroughly.
•To remove more stubborn dirt, use a suitable scraper (this is not supplied with the appliance). Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can obtain excellent results by using a rustproof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water.
•If plastic or sugary substances have accidentally been melted on the hob, remove them immediately with the scraper, while the surface is still hot.
•Once it is clean, the hob may be treated with a special protective maintenance product: the invisible film left by this product protects the surface from drips during cooking. This maintenance should be carried out while the appliance is warm (not hot) or cold.
•Always remember to rinse the appliance well with clean water and dry it thoroughly: residues can become encrusted during subsequent cooking processes.
. | ||
|
|
|
| ||
|
| |
|
|
|
| ||
| ||
| ||
|
| |
| " | |
| # | |
| $ $ | |
! | ||
|
|
|
Assistance
Please have the following information to hand:
•The appliance model (Mod.).
•The serial number (S/N).
This information can be found on the data plate located on the appliance and/or on the packaging.
10