Cleaning

The cleaning steps below are required to maintain maximum performance of your unit. Cleaning is very important to maintain Limited Warranty Coverage and is necessary every 3 to 6 months depending on the mineral content of your water.

1.Press the Power Button to turn Off

and unplug unit. Let unit cool at		CleanCycle Cleaning
least 10 minutes, then remove Water	4
		Crystal Packet

Tank Lid and empty all water.	(2 included)

2.Mix contents of 1 Cleaning Crystal packet with 4 oz. of water.

3.Pour solution into Water Tank and replace Water Tank Lid. Plug in unit, and press the Touch Sensor Power Button On.

WARNING: During cleaning, place unit where steam can be emitted safely. Steam should be directed away from objects or surfaces that may be affected by steam exposure.

4.Run unit until water level drops to the Min fill line on Water Level Window, or until steam is no longer emitted. Touch Power Button Off and unplug unit.

Let unit cool at least 10 minutes, then remove Water Tank Lid and empty.

5.Rinse unit by filling Water Tank with water to the Max fill line on Water Level Window. Swish around water inside the Water Tank, then empty all rinse water. The unit is now ready for use.

6.Any other servicing should be performed by an authorized service represen-

18tativeENGLISH.