Installation Instructions

Before Using Your Wine Cellar:

•Remove any exterior and interior packing material.

•Check to be sure the following parts are included:

♦2 slide out shelves: 1 full size, 1 half size

♦1 instruction manual

•Before connecting the appliance to the power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

•Place your appliance on a surface that is strong enough to support the appliance when it is fully loaded.

•To level your appliance, adjust the front legs.

•Ensure that the unit is installed with clearance of 1” on the sides and 4” in the back for proper air circulation.

•Designed for freestanding installation only, away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.

•Clean the interior surface with lukewarm water using a soft cloth.

•For maximum storage, place wine bottles both on their side and standing within the cooler. Remove metal half shelf and place bottles on their side on both the contoured metal shelf and the molded shelf. Stand bottles upright in bottom storage area.

OPERATING YOUR WINE CELLAR

It is recommended that you install the wine cellar in a place where the ambient temperature is between 50-80°F. If the ambient temperature is above or below recommended temperature, the performance of the unit may be affected. Placing in extreme cold or hot conditions may cause interior temperature to fluctuate. The range of 39-65°F may not be reached. Not intended for garage or basement installs. The temperature may fluctuate depending on whether or not the interior light is on or off or whether the bottles are located on the upper/middle or lower section. Close the cellar door immediately after putting in any items so the inside temperature will not rise dramatically.

8	W W W . V I N O T E M P . C O M