GENERAL
INSTRUCTIONS
USE THE CORRECT
AC VOLTAGE
Connecting the unit to an outlet supplying a higher voltage may create a fire hazard.
HANDLE THE POWER CORD Do not disconnect the plug from the AC outlet by pulling the cord; always pull the plug itself. Pulling the cord may damage it.
If you do not intend to use your unit for any considerable length of time, disconnect the plug from the AC outlet. Do not place furniture or other heavy objects on the cord, and try to avoid dropping heavy objects upon it. Also, do not make a knot in the power cord. Not only may the cord be damaged, it can also cause a short circuit with a consequent fire hazard.
PLACE OF INSTALLATION Place the unit on a firm and level surface. Avoid installing your unit under the following conditions:
•Moist or humid places.
•Places exposed to direct sunlight or close to heating equipment.
•Extremely cold locations.
•Places subject to excessive vibration or dust.
•Poorly ventilated places.
Do not obstruct the ventilation slots on the amplifier by placing objects over them, otherwise, the temperature inside the unit may rise, possibly affecting its long- term reliability.
MOVING THE UNIT
Before moving the unit, be sure to pull out the power cord from the AC outlet and disconnect the inter- connection cords with other units.
DO NOT OPEN THE CABINET To prevent shock hazard, do not tamper with internal components for inspection or maintenance.
JBL does not guarantee against performance degradation resulting from any modification. If water,
a hairpin, or wire, accidentally enters the unit, immediately extract the plug from the AC outlet to prevent shock and consult an authorized JBL service station. If you use the unit under this condition, it may cause a fire or shock hazard.
CLEANING
If the unit gets dirty, wipe it with a soft, dry cloth. If necessary, wipe it with a soft cloth dampened with mild soapy water and then with a dry cloth. Never use benzene, thinner, alcohol or other volatile agent, and avoid spraying an insecticide near the unit.
For Customers in the UK
Your unit is supplied with the flex which will have either two or three wires, so the following items should be observed to guarantee safety:
TWO CORE FLEX
IMPORTANT. The wires in this mains lead are colored in accordance with the following code:
Blue – Neutral
Brown – Live
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows:
The wire which is colored blue must be connected to the terminal which is marked with the letter N or colored black.
The wire which is colored brown must be connected to the terminal which is marked with the letter L or colored red.
3