Smeg FA 40X4, FA 40B4 Maintenance, Has the Appliance Stopped WORKING?, Safety, Technical Data

Page 5

itting of an angle brace for fixing

In order to prevent a detached larder-fridge from tilting forward when a filled fridge door is opened, an angle brace can be fitted.

Fit the angle brace on the wall behind the cabinet 80-100 mm from the left or right side of the cabinet depending on which side the door is hinged.

The angle brace must always be fitted in the opposite side of the door hinges.

Important!

In case of damage to the power cord it must be replaced by a power cord of correspond- ing type, available from the manufacturer or his service representative.

4. MAINTENANCE

Only use an unscented detergent when cleaning the cabinet inside.

Switch off the appliance and pull out the plug when cleaning the cabinet.

The skirting board can be removed to faciliate a vacuum cleaning of the floor. See fig. (1) page 20.

Remember to clean the drain in the refrigera- tor section also.

5. HAS THE APPLIANCE STOPPED WORKING?

Before calling a repairman, check that the plug is properly plugged into the wall socket.

The fuse is intact.

The power has not been cut off. All controls are correctly set.

Switch off the cabinet for 15 minutes (for instance at the thermostat). Switch it on again and after 5 minutes check whether frost has formed on the evaporator.

Do not open the cabinet when unnecessary. If the break appears to stretch over a longer period (over 12 hours) store the foodstuffs, if possible, in another appliance.

6. SAFETY

Do not store explosive substances in the refrigerator section, such as gas, cigarette lighters, petrol, ether or similar.

Scrapped cabinets may become dangerous to children at play. Therefore, remove the doors or place the scrapped cabinet in such a way that children cannot enter it.

7. TECHNICAL DATA

This appliance meets the provisions of the following directives:

89/336/EEC (electromagnetic compatibility), 73/23/EEC (electrical equipment designed for use within certain voltage limits) as amended. Household appliances sold in the EU also meet 96/57/EEC (energy efficiency require- ments) as amended.

The rating plate, which is placed either at the back or inside the appliance, see fig. (5) page 21, provides various technical information as well as type and serial number.

8. INSTALLATION

See drawings (1) and (2) page 20.

Install the cabinet in a dry place and so that it is not exposed to direct sunlight or any other source of heat.

Place the cabinet in a level position. This is easily achieved by adjusting the adjustable feet at the front edge of the base. The cabinet should not rest against a wall on its hinged side. When placing the cabinet on a carpet or on a wooden floor, the placing should be checked after a while to see whether the unit has „subsided“ into the soft flooring.

The cabinets can be built in or put side by side, see fig. (2) page 20.

For sufficient airflow around the cabinet it is necessary to have a 50 mm high air duct right above the appliance, see fig. (2) or an air duct that leeds the air up over the top cupboard.

Make sufficient space for door opening, see fig. (2).

The dimensions for building in are noted on the drawings.

It is safest to place the earthed wall socket above the appliance and at least 2.0 m above the floor.

Any local installation rules for appliances of this kind must be observed.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents FA 40B4 Page Page HOW to USE the Appliance ContentsGeneral Advice on the USE of the Appliance Before Starting the RefrigeratorSafety MaintenanceTechnical Data InstallationDisposal Appliance Change of Hinge SideContenu Avant LA Mise EN ServiceComment Utiliser Votre Appareil ConseilsInstructions D’INSTALLATION Specifications TechniquesEntretien EN CAS DE PanneChangement DU Sens D’OUVERTURE DES Portes Instalacion E Inspeccion IndicePanel DE Mandos Y SU Utilizacion Algunos Consejos Para EL USO DiarioConsejos DE Seguridad EntretenimientoDatos Tecnicos Instalacion Electrica Y AlineamientoRemoción DEL Aparato Cambio DEL Sentido DE Apertura DE LAS PuertasUtilizzo DEL Frigorifero Prima DI Collegare IL FrigoriferoConsigli Generali PER L’UTILIZZO DEL Frigerifero Regolazione della temperatura nella parte refrigerataPulizia E Manutenzione InstallazioneCaso DI Guasto SicurezzaEliminazione DELL’APPARECCHIO Gebruik InhoudAlvorens UW Toestel in Werking TE Stellen Temperatuurregulatie kelderruimte KelderruimteTemperatuurregulatie Algemene RaadgevingOnderhoud InstallatieIndien UW Toestel Niet Werkt VeiligheidDeur afstellen Het toestel waterpas plaatsenAls 2 apparaten naast elkaar worden gezet HET Wijzegen VAN Deurophang600 1560 610 Page

FA 40X4, FA 40B4 specifications

The Smeg FA 40B4 and FA 40X4 are remarkable models of built-in ovens designed to enhance cooking experiences while integrating seamlessly into modern kitchens. Smeg, known for its stylish design and cutting-edge technology, has produced these models to cater to both professional chefs and home cooking enthusiasts.

One of the standout features of the FA 40B4 and FA 40X4 is their robust capacity, allowing users to cook multiple dishes simultaneously. With an interior volume of 70 liters, these ovens provide ample space for large meals, making them ideal for families and gatherings. The ergonomic design also ensures that the oven's controls and features are easily accessible.

Both models incorporate Smeg’s advanced multifunctional cooking systems. Users can choose from various cooking modes such as conventional cooking, fan-assisted heat, and grill options, providing versatility to suit different culinary needs. The inclusion of a ventilated oven ensures even heat distribution, resulting in consistent cooking outcomes regardless of the dish.

Another significant feature is Smeg's unique Thermo-ventilated technology. This innovation allows for perfect moisture control within the cavity, which is particularly beneficial for baking, as it helps achieve optimal crust and crumb structures. The even temperature distribution also minimizes the risk of overcooking, ensuring that every meal is cooked to perfection.

Ease of cleaning is another critical aspect of these ovens. The FA 40B4 and FA 40X4 come equipped with a Hydro-cleaning function, which uses steam to loosen food residues, making it simpler for users to maintain their ovens in pristine condition without the need for harsh chemicals. Additionally, the enamel interior surface is specially designed to resist sticking and facilitate quick cleaning.

Both ovens feature a sleek, modern design with a stylish stainless-steel finish that complements any kitchen decor. The clear digital display and intuitive controls offer a user-friendly interface, allowing for precise temperature adjustments and timer settings.

Safety features are paramount in the design of these models, with triple-glazed glass doors that minimize heat escape while ensuring a cool-to-touch exterior. This design promotes a safe cooking environment, particularly in households with children.

In summary, the Smeg FA 40B4 and FA 40X4 are exemplary built-in ovens that combine functionality, advanced technology, and elegant design. With their extensive features and user-friendly characteristics, they are a perfect choice to elevate any kitchen experience while delivering exceptional culinary results.
Top Page Image Contents