Smeg FAB28JNE, FAB28JP, FAB28JR, FAB28JO, FAB28JCS, FAB28JAZ, FAB28JBL manual Instructions for the user

Instructions for the user

PROBLEM		POSSIBLE CAUSE				PROBABLE SOLUTION
Too much ice forming on back wall	of -	Cooling	temperature	regulator	-	Turn the regulator to a lower
refrigerator section (layer of frost		device set too high (meaning				setting (1-2) to increase the
more than 1 cm thick):		lower	temperature inside the			temperature inside the appliance
		appliance);				slightly;
					-	check that the gaskets are
						providing an airtight seal;
	-	door opened often or for long			-	open the door less often and for
		periods;				shorter times;
					-	rise	in	atmospheric		temperature
						and humidity;
					-	do not place hot food or drinks
						inside the refrigerator;
					-	Turn the regulator to a lower
Too much ice forming in freezer	-	inside	temperature	setting
		thermostat set on too low a				setting (1-2) to increase the
		temperature;				temperature inside the appliance
						slightly;
					-	check that the gaskets are
						providing an airtight seal: If they
						are cracked, try to soften the
						gasket by pulling it with one hand
						and sliding your closed fingers
						along the inside;
					-	open the door less often and for
						shorter times;
					-	rise	in	atmospheric		temperature
						and humidity;
					-	do not place hot food or drinks
						inside the freezer;
					-	the	refrigerator		is	operating
Front of cabinet hot to the touch	-
						normally. Inside the cabinet there
						is a surface cooling system
						designed to restrict the formation
						of condensation in the area where
						the door gasket closes.
					-	check that the refrigerator is
Doors misaligned (except mod. -
FAB28)						levelled		properly,	also adjusting
						the two rear feet if necessary.
						Check		whether	changing the
						settings of the two feet improves
						the alignment.

18