Auralex Acoustics EPS-112T manual CT45 Bass Trap Installation Guide

Page 3

CT45 Bass Trap Installation Guide

Mark a vertical line 16.75” from the intended placement corner on both sides.

Hold CT45 Bass Trap in corner with edges aligned to the marked vertical lines.

16.75”

While continuing to hold panel in place, install one finish nail though the fabric face and the hardened edge of the CT45. Do not hammer nail completely flush with the face of the panel. Make sure finish nail is installed perpendicular to the wall surface. Repeat in each of the four corners.

Using a nail set or another finish nail, carefully countersink installed nail so its head goes through the fabric surface of the CT45 but not through the hardened edge.

Once the finish nail has been countersunk into the panel, there may be a small hole remaining in the fabric covering. Simply scrape the fabric in this area with your fingernail and the hole will completely disappear.

Image 3
Contents Elite Pro System EPS-112T Components Elite Pro SystemsElite Pro System EPS-112T General Information B22 ProPanel Installation GuideCT45 Bass Trap Installation Guide About these and other Total Sound Control products Elite Pro System Installations