Smeg FD250A Transport instructions, Disposal, Appliance setup, Location, Electrical connections

Page 7

en

en

Transport instructions

The device should be transported only in upright position.

The packing as supplied must be intact during transportation.

After a transport in the horizontal position, the device may only be taken into operation 4 hours after being stood up vertically again. The appliance must be protected against rain, moisture and other atmospheric influences. The manufacturer assumes no liability if safety instructions are disregarded.

Disposal

Make the device unusable immediately. Pull out the mains plug and cut the power cable. Remove or destroy snap or latch locks before disposing of the device. In this manner you prevent children from locking themselves in and endangering their lives.

Appliance setup

Do not operate your appliance in a room where the temperature is likely to fall below 10 °C at night and/or especially in winter. At lower temperatures the appliance may not operate, resulting in a reduction in the storage life of the food.

The climate class rate of your appliance is given on the rating label located inside the appliance. It specifies the appropriate operating ambient temperatures as explained below.

Climatic class

Ambient temperatures

SN

+10 °C to 32 °C

N

+16 °C to 32 °C

ST

+18 °C to 38 °C

T

+18 °C to 43 °C

SN-ST

+10 °C to 38 °C

SN-T

+10 °C to 43 °C

Location

Only place the device in dry rooms which can be aired.

Avoid direct sunlight or direct heat sources such as a stove or a heater.

If this cannot be avoided, the following minimum distances should be maintained: Electric stoves: 3,00 cm

Heater: 3,00 cm

Cooling devices: 2,50 cm

Ensure sufficient air circulation for your device.

Make sure that sufficient room is provided around the appliance to ensure free air circulation.

Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn to the condenser at the back of the appliance (Fig. 3).

The device should be located on a smooth surface. The two front feet can be adjusted as required. To ensure that your appliance is standing upright adjust the two front feet by turning clockwise or counter-clockwise, until the product is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise.

Electrical connections

Warning

This appliance must be grounded.

Check whether the power type and voltage in your region corresponds to the one stated on the rating label inside the appliance.

The electrical safety of the appliance is only assured when the grounding system in the house is installed in accordance with regulations.

When placing the appliance, do not let the power cable get stuck under it; otherwise the cable will be damaged.

Ensure that the plug remains readily accessible. Do not use a multiple adapter bar or an extension cable.

The electrical specifications of your appliance is given on the rating label located inside the appliance.

Route power cable to allow easy connection and disconnection after installation.

A contact separator should be used if the power cable is not accessible. (for built-in models)

2

Image 7
Contents FD250A It-Indice En-IndexPage Page 180 Safety comes first Location Appliance setupTransport instructions DisposalGet to know your appliance Prior to startup Max. = Highest cooling settingFood storage CoolingDefrosting of the device Freezing food FreezingCollecting container Pan Cleaning and careSwitch off at the socket outlet and pull out the mains plug Door shelvesCooling Practical tips and notesFreezing Normal operating noises Examples of UseReversing the doors What, ifEnergy 48 3724 00