JBL PSW-D115 setup guide + +

2)If your receiver/amplifier has subwoofer outputs or preamp output jacks for the left, center and right channels, or left and right only.

If your receiver/amplifier has a single (mono) sub- woofer output or LFE out-

put, you may connect the output to either the Left, Right or Center line-level input on the subwoofer.

However, to maximize the subwoofer’s performance, we recommend that you use a “Y”-connector (not includ- ed). Plug the single male end of the “Y”-connector

into the subwoofer output on the receiver/amplifier, and connect each of the

2 female connectors to an RCA-type interconnect cable. Then connect the 2 interconnect cables to the Left and Right line-level inputs on the PSW-D115.

3)If your receiver/processor contains Dolby* Digital or DTS® surround processing technology, then connect the subwoofer or LFE out- put from your receiver/ processor to the Center line-level input as shown.

Set the “Low-Pass” control to the 180Hz position.

When hooked up using this method, all of the crossover and level adjustments are con- trolled through the receiver/ processor.

SPKR In

L

C

R

SPKR Out

L

C

R

Power

OffOn

+ +

0 180 Phase

L	L L
I	I
N	N
E	E C
O	I
U	N	R
T
	Direct
	120
90	150

High

60180 Pass

120

90150

	Low
60	180 Pass

+

RECEIVER/AMPLIFIER

SUBWOOFER OUT

LEFT RIGHT

MAIN SPEAKER OUTPUT

RIGHT + – – + LEFT

	+ –			– +
		RIGHT		LEFT
LOUDSPEAKER			LOUDSPEAKER

	SPKR In
	L
		0	180	Phase
	C	L		L	L
		I		I
		N		N
	R	E		E C
		O		I
		U		N	R
		T
	SPKR Out
	L		Direct
RECEIVER/PREAMPLIFIER			120
Subwoofer	C	90		150
					High
Output		60	120	180	Pass
	R	90		150
					Low
		60		180	Pass
		Power
	Off	On
	+	+		+

+ + +

+ + +

– 4 –