Smeg PGF95K-3 manual Attachment to support structure, flush-mounting model

Instructions for the installer

2.2Attachment to support structure, flush-mounting model

Create an opening with the dimensions

shown in the figure in the work surface,
observing a minimum distance of 50 mm
from the rear edge.
The lower part of the protective cover
must be fully accessible when the
appliance is installed. This appliance can
be installed next to walls that are higher
than the work surface, as long as the
distance "X" is kept, as shown in the	1)
figure, to avoid damage from overheating.

Make sure there is a minimum of 750 mm (Fig. 1) between the gas rings and any shelf that may be installed directly above them. This type of appliance also requires a cut 3

mmdeep in the work-top with the dimensions shown in figure 4 (detail A, figure 2). Before positioning the hob, position the adhesive sponge material “E” supplied over the milled surface (fig. 2). Now place the hob on the cut in the work-top and use the screws and fixing brackets (sequence shown in Fig. 3) to secure the hob to the supporting structure, adjusting it until perfectly horizontal. Do not fit the brackets shown in fig. 3 until the hob has been set in place.

3)

2)

Mill to this depth for laminated worktops of less than 3mm thickness.

4)

Apply a layer of “waterproof primer” to the milled surface.

Important: Other types of installation will only be possible under the manufacturer's supervision.

23