Smeg KCVR9NE instruction manual Electronic control system instructions for use, Technical Features

EN

Electronic control system instructions for use:

Technical Features:

•Power supply from mains: 230 VAC – 50/60 Hz

•Power consumption in standby: 20 mA

•Max. load applicable to LIGHTS connection: 150 W

•Max. load applicable to MOTOR connection: 400 W (capacitor motors only)

•Microprocessor-controlled electronic control system.

•Loads managed by solid-state components, opto-isolated from the mains.

•Hardware and software EMC filtering.

•Connection to electronic control board by flat cable (10 poles) protected by flexible sheath (outside diameter 8 mm). Low voltage circuits (5 V).

•Possibility of operating an optional load at mains voltage.

•Non-volatile internal memory (EEPROM) for storing system settings and flags.

•Optional analog/digital input for sensor and/or external control.

•Phase-cutting motor control.

•SOFT-START light switch: turn the lights on gradually to guarantee better performance of electronic components.

•Automatic sensing of mains frequency:

number 50 flashing on display = 230 VAC – 50 Hz mains, number 60 flashing on display = 230 VAC – 60 Hz mains,

•Software-enabled reception of remote control commands: all the hood's main functions can be controlled by an IR remote control protected by a propriety code, operating at 24+1 bit and with an IR carrier frequency of 36 KHz.

•Software set-up procedure for selecting and permanently storing blower motor settings and enabling A.C. filter saturation alarm (for filter hoods).

•FILTER saturation alarm and alarm reset control (hour TIMER

for hood work).

KCVR9NE