JBL L226W, LS326W manual Existing Construction, L226C, L228C, LS326C, LS328C

EXISTING CONSTRUCTION

L226C, L228C, LS326C, LS328C

≥1/2"

≥1/2"

≥1/2"

1. Remove the plastic paint	2. Determine the correct
shield from the speaker frame.	speaker location.
	NOTE: Use the included
	template when cutting the
	drywall.

5. Connect the speaker	6. Make sure all four locking tabs
wires to the speaker.	are properly positioned against
	the locking tab stops that are
	located on the speaker frame (see
	Figure 5 below). After confirming
	this, carefully place the frame
	assembly in the wall and confirm
	that there is no more than 1/8-inch
	play between the frame and the
	wall cutout. After positioning the
	speaker in the mounting location,
	back each screw out one full turn
	(turn counterclockwise).
	Figure 5.

3.NOTE: Always allow at least a 1/2 inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.

7.Screw down each of the four Phillips-head screws, alternating between the four screws. The locking tabs will swivel into place and secure the unit to the rear surface of the wall panel. Hand- tighten with a nonpowered, straight-handle regular screw- driver only. Do not use a socket wrench, a powered screwdriver, a drill or any other powered tool. Confirm that the speaker is firmly and securely held in place and that all four locking tabs are firmly resting against the wall panel.

4.Ensure that the drywall or plywood board or other appropriate wallboard is at least 1/2-inch thick and confirm that the board material is capable of withstanding the weight of the speaker you will be installing. Cut the drywall.

8.Attach the metal grille and logo, if desired.

4