Smeg LVS655EG instruction manual Operating instructions, Using the water softening system

Page 18

User instructions

4. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

Adjust the water softening system;

Add the regenerating salt;

Add the rinse aid and detergent.

4.1Using the water softening system

The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with an automatic

softening system which uses a specialSALT regenerating salt to reduce the hardness

of the water.

The dishwasher is factory set for water hardness level 3 (average hardness 41-60°dF24-31°dH).

When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.7 Kg of salt in grains. Some models are equipped with an optical no-salt indicator. In these models, the cap of the salt container contains a green float which descends as the salt concentration in the water drops. When the green float can no longer be seen through the transparent cap, the container must be topped up with regenerating salt. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening.

When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container.

Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated.

Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely.

53

Image 18 Contents
Guide for Using the Dishwasher and the Washing Programs Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation instructions Installation and hook-upConnecting to the Water Supply Water supply connectionDrain Connection Electrical connection and precautions When Cleaning and Maintaining the ApplianceDescription of the controls Front panel130 105 115 Only run the soak program with half loads Washing programs Table for Certification BodiesLighting Programming Selection ProgramStart Program END Program Interruption of a ProgramTo Change a Program Annulling a Program Half Load Wash Function on some models onlyDelay Program on some models only User instructions To Save on ENERGY! … and Protect the Environment Removing the DishesUsing the water softening system Operating instructionsAdjusting the Water Softening System Using the rinse aid and detergent dispensers Water Hardness TableAdjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent User instructions General warnings and recommendations User instructions Using the baskets Lower BasketLoading the Lower Basket Cutlery Basket Upper Basket Loading the Upper BasketAdjusting the Upper Basket Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Cleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Troubleshooting Code Phases Lights DescriptionIf the problem persists, contact the after-sales service 135 145
Related manuals
Manual 36 pages 24.81 Kb