Smeg DWD63BLE, DWD63SSE instruction manual Troubleshooting, Dishwasher fails to heat the water

User instructions

FAULT

E1

ż ż ż Ɣ

E2

Ɣ ż ż Ɣ

E3

ż Ɣ ż Ɣ

E4

Ɣ Ɣ Ɣ ż

E5

Ɣ Ɣ ż Ɣ

6. Troubleshooting

The electronic control system is able to find and signal a series of possible malfunctions of the dihwasher by means of PROGRAM PHASES INDICATOR LIGHTS (8), which illuminate following well determined sequences, corresponding to different problems.

In the event of a fault or malfunction, before calling the After-sales service centre, we suggest that you first consult the troubleshooting guide below.

If the problem persists even after implementing the recommended solutions, call the After-sales service centre after having carried out the following:

•making a note of the fault message (E1, E2, …);

•unplug the power cord from the socket;

•shut off the water supply tap.

TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM DESCRIPTION

The dishwasher’s AQUASTOP anti-flooding system has been activated (only for models equipped with the device).

To reset the signal failure, you must switch off and restart the appliance. You must also call the AFTER- SALES SERVICE to find out what caused the problem.

The system for limiting the water level in the dishwasher has been triggered.

It could be a temporary failure. Try opening and closing the dishwasher door and starting the appliance again. If the problem persists, call the authorised technical service centre.

The dishwasher fails to heat the water.

Try opening and closing the dishwasher door and starting the appliance again.

If the problem persists, call the authorised technical service centre.

The washing temperature sensor is disconnected.

Call the After-sales Service.

The dishwasher fails to draw water.

Check that:

•the water supply tap is open;

•the filter in the water intake hose is not clogged;

•the water intake hose is not kinked or bent.

Once you carried out these operations, switch the appliance off and start it again, press the ON/OFF button again and the program will restart from the point at which it was interrupted.

If the problem persists, call the authorised technical service centre.

E6

Ɣ ż Ɣ Ɣ

The dishwasher fails to drain.

Check that:

•the flexible drain hose is not kinked or obstructed;

•the water drain pipe is not obstructed;

•the dishwasher filter is not clogged.

Once you carried out these operations, switch the appliance off and start it again, press the ON/OFF button again and the program will restart from the point at which it was interrupted.

If the problem persists, call the authorised technical service centre.

E9 There is a malfunction in the water filling system.

ż ż ż Ɣ	Call the After-Sales Service to find out what caused the problem.
	In the event of error codes not included in this table, call the Technical Service Centre.

41