Smeg AP64S3 manual Adaptation to Different Types of GAS

Instructions for the installer

5 ADAPTATION TO DIFFERENT TYPES OF GAS

Before performing any cleaning or maintenance work, disconnect the appliance from the electrical socket.

The hob has been inspected for G20 (2H) natural gas at a pressure of 20 mbar. For functioning with other types of gas the nozzles must be replaced and the primary air adjusted.

To replace the nozzles and regulate the burners, you have to remove the top as described in the following paragraph.

5.1Removing the separable control panel (models with separable control panel)

1.Remove the knobs and the knob guard tube “A” by pulling them up;

2.Use a crosshead screwdriver to remove the screws and the two cylindrical supports “B”;

3.Raise the left-hand side of the control panel slightly and shift it to the right to remove it completely;

4.In models with electric hotplate, the body of the pilot light has to be removed to free the control panel;

5.2Removing the hob (models with integrated control panel)

1.Remove the knobs, the griddles, the burner caps, the flame caps and the two rear plugs;

2.Remove the screws “A” which fix the burner supports;

3.Raise the hob, sliding it off the ignition plugs and/or the thermocouples and the gas tap rods;

32