Smeg SCA708X, SCA710X, SCA705X manual Demo Function

Page 11

Instructions for the user

Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hours after the current time). To set the cooking start/end time, proceed as follows.

-Set the cooking duration time as described in the previous point.

-Within 6/7 seconds after the last time the or keys are pressed, press the key to set the cooking start time. The display

will show the current time with the inside segments indicating the

cooking end time illuminated. Use the and keys to set the cooking start time.

-6/7 seconds after the last time a key is pressed, the display will show the current time and the cooking start and end times, indicated by the illuminated inside segments. The segments on the display will be constantly on until the current time is the same as the cooking start time; as soon as the current time reaches the cooking start time set, all the inside segments will start to flash, indicating that the oven has started cooking.

-When the end of the cooking time is reached, the timer will switch off the oven heating elements, the beeps will start and the numbers on the dial will flash.

-To reset the entire program set, keep the central key pressed for 1 or 2 seconds: if cooking has already started the oven will have to be switched off by hand.

- The image on the right shows an example of programming: the current time is 7.06 and cooking is programmed to start at 8 o'clock and finish at 9.

- At 8 o'clock, the inside segments between 8 and 9 will start to flash and the hour pointer will remain still.

Caution: for the oven to start cooking after the programming procedure just described, the thermostat and function selector must be properly set on the temperature and function required.

3.2.4 "DEMO" Function

Models with analogue/digital programmer feature a "DEMO" function which deactivates the heating elements while leaving the other functions

unchanged. To activate it, simply press the , and keys and keep them held down for 3/4 seconds. A confirmation buzzer will inform the user that the function is active. When the “DEMO” function is active, the number 6 on the clock flashes at regular intervals. To deactivate it, simply repeat the same procedure.

13

Image 11
Contents Contents Instructions for Safe and Proper USE IntroductionPlate Must not be Removed This label must never be removed InstallationElectrical connection Installing the oven Front control panel Description of ControlsPilot Light Green Electronic Analogue Clock Setting the timeMinute-minder Programming Demo Function Semiautomatic cooking Clock adjustmentElectronic programmer End of cooking Adjusting alarm volumeSwitching off the alarm Automatic cookingChanging the set data Cancellation of set dataOven light USE of the OvenCooling system Some models do not feature all accessories Available AccessoriesFan cooking Cooking HintsTraditional cooking 200 Grill cookingFan grilling Grill function must be used only with the door closedDefrosting Delicate cooking200 Spit roastingRecommended cooking table Traditional CookingFAN Cooking Ordinary Daily Cleaning Cleaning and MaintenanceCleaning stainless steel Cleaning of the oven without self-cleaning panelsAssembling the self-cleaning liners Self-cleaning liners only on some modelsUsing the self-cleaning liners Looking after the self-cleaning linersWith type 1 mobile levers Removing doors with pinsRemoving the door Removing the door glazingInstructions for the user Oven door seal Additional MaintenanceReplacement of light bulb 914773616/ a