Smeg SC709X manual Removing the glass panels, Removing the door with pins

Instructions for the user

7.4.2 Removing the door with pins

Open the door completely and insert the pins (supplied) into the holes from the inside. Close the door to an angle of about 45° and lift it off. To reassemble, fit the hinges into their grooves, then lower the door into place and extract the pins. If the pins get lost, two screwdrivers can also be used.

7.5 Removing the glass panels

The glass in the door should always be kept thoroughly clean. For easier cleaning, the door glazing can be fully removed by proceeding as described below. After opening the door and locking it in place as described in point “7.4 Removing the door”, remove the internal glass pane levering it as illustrated in figure 1, and detach the 4 pins that fix the glass to the door. If your oven also has a middle glass pane (figure

2)this can be extracted simply by lifting it upwards. After having carried out the cleaning, first of all replace the middle glass panel (if your oven has one), and then position the internal glass hinging it, as shown in figure 3, on the grooves of the oven door (see part A in figure 3). When the glazing has been positioned on the door, exert a slight pressure on the four fixing pins.

If the door should close during these operations, simply relock one of the hinges as described in point “7.4 Removing the door”. The glass panels can now be washed separately.

56