Smeg OF602XA, OF902XA Extraordinary Maintenance, Replacement of light bulb, Removing the door

Page 12
11.EXTRAORDINARY MAINTENANCE

Instructions for the user

11.EXTRAORDINARY MAINTENANCE

The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations.

Before any intervention, disconnect the power supply of the device.

11.1 Replacement of light bulb

Remove cover A by twisting anticlockwise, replace bulb B with another similar bulb (25 W). Refit the cover A.

Only use oven bulbs (T 300°C).

11.2 Removing the door

Hold the door on both sides with both hands near hinges A and raise levers B. Lift up the door forming an angle of about 45° and remove. To refit, slide the hinges A in the grooves, drop the door and release levers B.

11.3 Oven door seal

To permit thorough cleaning of the oven, the seal may be removed. Before removing the seal, take off the door as described above. Once the door has been taken off, lift the tabs at the corners as shown in the figure.

14

Image 12
Contents Contents Instructions for proper use 1. INSTRUCTIONS FOR PROPER USE2. DISPOSAL INSTRUCTIONS - OUR ENVIRONMENT POLICY THE PLATE MUST NOT BE REMOVEDSafety instruction 3. SAFETY PRECAUTIONDO NOT INSTALL THIS APPLIANCE ON A RAISED PLATFORM NEVER UNPLUG BY PULLING ON THE CABLEInstructions for the user 4. INTENDED USE OF THE APPLIANCE5. BEFORE FIRST USE 6. USE OF THE HOB 6.1 Cooking zoneMake sure that children never touch the cooking hob 7. FRONT CONTROL PANEL ELECTRONIC PROGRAMMER”COOKING HOB CONTROL KNOB Standard heating Double heatingOVEN THERMOSTAT KNOB OVEN CONTROL KNOB8.1 Warnings and general advice 8.4 How to use the grill8. USE OF THE OVEN 8.2 Cooling system9.1 Clock adjustment 9.2 Setting the timer9.4 Adjusting the volume of the acoustic device 9. ELECTRONIC PROGRAMMER10.CLEANING AND MAINTENANCE 10.1 Cleaning stainless steel10.2 Ordinary daily cleaning 10.4 Cleaning the glazed ceramic hob10.5 Cleaning of oven 10.6 Door glass11.EXTRAORDINARY MAINTENANCE 11.1 Replacement of light bulb11.2 Removing the door 11.3 Oven door sealInstructions for the installer 12.INSTALLATION OF THE APPLIANCE12.1 Electrical connection The plate must not be removed12.2 Wall fixing where applicable 12.3 Mounting the rear top skirtboard where applicablePage 914773157/ C