Audio-Technica AT-PL50 manual Specifications, Tips For Better Performance

Page 7

Troubleshooting, continued

Turntable operates, but no sound at all

1.The stylus guard is still in place.

2.The tone arm Lift button is pressed in.

3.Amplifier controls set incorrectly: wrong input select- ed, tape monitor on, speakers switched off, etc.

4.Check the stylus on phono cartridge for correct place- ment. Refer to the instructions for replacing the stylus on page 5.

Turntable operates, but no sound, or sound not loud enough

1.If the turntable is connected to an AUX (high-level) input: The Pre-amp Selector Switch may be set to the “OFF” position (phono-input level).

2.The input gain of the amplified speaker or similar device may be too low.

3.The stylus assembly may not be fully seated in the cartridge body. (See Fig. 9 on page 5.)

Sound is very distorted

1.Turntable connected to an amplifier’s PHONO input: If the pre-amp switch is set to the “ON” position (AUX high-level output), a phono input will be overloaded.

Turntable moves slightly up and down

1.Usually this is a normal condition and not a problem. If this causes the turntable to be unable to trace the record, please contact your dealer or our service department. Make very certain the surface upon which the turntable is resting is not picking up vibrations from the floor or walls, or from direct speaker sound.

 

 

Specifications

 

 

Type

Belt drive turntable, fully automatic

 

 

 

 

 

 

Platter

Aluminum

 

 

 

 

 

 

Motor

DC servo-controlled

 

 

 

 

 

 

Speeds

331/3 / 45 rpm

 

 

 

 

 

 

Wow and flutter

0.25% WRMS

 

 

Signal-to-noise ratio

45 dB

 

 

Cartridge

Integral Dual Magnetstereo cartridge

 

 

 

with diamond stylus

 

 

Output level

 

 

 

Preamp “Off”

2.5 mV nominal at 1 KHz, 5 cm/sec

 

 

Preamp “On”

200 mV nominal at 1 KHz, 5 cm/sec

 

 

Phono preamp gain

38 dB nominal, RIAA equalized

 

 

Power

120V AC, 60 Hz, 3W

 

 

Dimensions

14.17" W x 3.82" H x 14.06" D

 

 

 

360 mm W x 97 mm H x 357 mm D

 

 

Net weight

5.3 lbs. (2.4 kg)

 

 

Furnished accessories

Dual RCA (female) to 1/8" (3.5 mm) mini-

 

 

 

plug (male) stereo adapter cable; dual

 

 

 

RCA (female) to 1/8" (3.5 mm) mini-plug

 

 

 

(female) stereo adapter cable; 45 rpm

 

 

 

adapter

 

 

Replacement stylus

ATN3600L

 

Tips For Better Performance

When opening or closing the turntable cover, handle it gently, moving it either at the center or equally from both sides.

Do not touch the stylus tip with your fingers; avoid bumping the stylus on the turntable mat or a record’s edge.

Clean the stylus tip frequently, using a soft brush with a back-to-front motion only.

If you use a stylus cleaning fluid, use it very sparingly.

Wipe the dust cover and turntable housing gently with a soft cloth. Use only a small amount of mild detergent solution to clean the turntable and dust cover.

Never apply harsh chemicals or solvents to any part of the turntable system.

Prior to moving the turntable, always unplug it from the AC outlet and fasten the tone arm on the tone arm rest with the vinyl twist-tie.

7

Image 7
Contents Automatic Stereo Turntable System Introduction Automatic Stereo Turntable System2b Record mat 2c Dust cover removal Initial SetupSetting the Pre-amp Switch Assembling the TurntableAutomatic Operation Connecting to Stereo SystemConnecting to Computers or Audio Devices with 3.5 mm Input OperationManual Operation Replacing the Stylus7b7c Turntable does not operate Troubleshooting10e Tips For Better Performance SpecificationsOne-Year Limited Warranty

AT-PL50 specifications

The Audio-Technica AT-PL50 is a notable entry in the realm of affordable yet high-quality turntables, blending modern technology with classic analog sound. Designed for both casual listeners and audiophiles, the AT-PL50 impresses with its mixture of features, build quality, and audio performance.

One of the standout characteristics of the AT-PL50 is its fully automatic operation. This means that the turntable can detect the record's size and adjust the tonearm accordingly, allowing for a hassle-free experience when playing vinyl. The automatic lift system ensures that the tonearm safely lifts when the record finishes, helping to prevent unnecessary wear on both the vinyl and the stylus.

The AT-PL50 is equipped with a high-quality dual magnet cartridge which provides precise tracking and exceptional sound quality. This cartridge allows for an accurate reproduction of music, making it suitable for a variety of genres. The user-friendly design includes a switchable phono preamp, enabling users to connect the turntable to a wide range of audio systems without the need for an additional preamp.

In terms of build quality, the Audio-Technica AT-PL50 features a sleek and minimalist aesthetic. The durable plinth minimizes vibrations, which contributes to improved sound clarity. The heavy-duty platter plays a vital role in maintaining stable playback speed, enhancing the overall listening experience. Additionally, the anti-skate adjustment feature aids in ensuring balanced and distortion-free tracking.

The AT-PL50 also embraces modern connectivity options, making it versatile for today's audio environments. With its USB output, users can digitize their vinyl collection, making it easy to enjoy their favorite records in a digital format. This feature caters to those who appreciate the warmth of vinyl but also want the convenience of digital music.

Overall, the Audio-Technica AT-PL50 stands out as a well-rounded turntable that combines stylish design with practical functionality. Its automatic features make it accessible for newcomers to vinyl, while the advanced technologies ensure that it meets the performance standards of seasoned audiophiles. Whether you're just starting your vinyl journey or looking to upgrade your system, the AT-PL50 is a compelling choice for anyone seeking quality sound and ease of use in a modern turntable.