Reverse door swing

Required tools; socket spanner nr. 8, screwdriver, torx 25

Caution! After unscrewing of before ﬁxing hinges, hold the door to prevent it from falling and damaging.

1.Remove upper hinge cover (keep it for eventual later use), together with cover on the opposite side of the upper hinge cover (on the opposite side you will insert the attached cover during the assembly), and remove the cover on the opposite side of the upper part of the door.

2.Unscrew upper hinge screws and remove the door from the bottom hinge.

3. On the bottom side of the door unscrew the swing stopper screws and remove the stopper

(A) keep this stopper for later use. Fix the attached stopper with its bearing on the opposite side of the door.

4.Unscrew the forced door closure system (B) and ﬁx it to the opposite side of the door (certain models only).

5.Remove handle screw covers, unscrew handle screws, and remove plastic pegs on the opposite side.

6.Tilt the appliance backward (max. 35°) to lean to the rear side of the cabinet. Unscrew the leg

support screws (C) - left and right, and remove the leg support cover (D). Unscrew and remove, then reciprocally replace the position of end switch (E) and decorative peg (F) (for models with forced door closing system). Place this on opposite side. Unscrew three screws ﬁxing the bottom hinge (keep the hinge for later use), and ﬁx the attached bottom hinge on the opposite side.

7.Proceed with the assembly procedure in opposite sequence.