Sub-Zero 542 manual Tructions, Electrical Instructions, Plumbing Instructions, Unpacking

i	ii	I	I	I
	I	!

-INSTALLATION

TRUCTIONS

,REA

[_,WARNING l

!

REPARATION

;tep 2

A/hen units are installed side

3y side, a separating filler strip s recommended. The filler

_trip width should be added to he finished rough opening

dimension. A filler strip must _lso be used when units are

nstalled hinge to hinge.

IMPORTANT." For proper operation and use the door must open a minimum of 90 °. A minimum 2" filler must be used in corner installations to assure a 90 ° door opening. Remember to allow enough clearance in front of unit for full door s_;r)g. Minimum door

....,'ance listed in Figure 2.

IMPORTANT NOTE: We also require the floor under

the refrigerator to be at the same level as the

surrounding finished floor.

IACAUTION ]

Any finished flooring should be protected with appropriate material to avoid damage from very heavy appliance.

If unit fits under soffit with clearance between top of unit and soffit of 1" or less as in Figure 3 unit does not require blocking, otherwise blocking is

=required. Refer to step.8.

Figure 3

ELECTRICAL

INSTRUCTIONS

Step 3

Rough in the electrical outlet following the "Pre-lnstallation Specifications". See Figure 1.

A 115 volt, 60 Hz, 15 amp fused electrical supply is required. Itis recommended that a separate circuit, serving only this appliance, be provided.

Follow any other local codes or ordinances that may also apply.

Do not use an extension cord, or two prong adapter. Electrical ground is required on this appliance.

Do not under any circumstances remove

the power supply cord ground prong.

This appliance is factory equipped with a power supply cord with a 3-prong grounding plug. It must be plugged into a mating 3-prong grounding

type wall receptacle grounded in accordance with the

National Electrical Code and local codes and ordinances. See Figure 4.

PLUMBING

INSTRUCTIONS

Step 4

For units with automatic

icemaker, rough in the water supply line.

Connect a %" copper line to the house supply being sure to use an easily accessible shut off valve between the supply and your refrigerator (approximately 6" from the compression fitting). The icemaker operates on water pressure of 20 to 100 PSI.

NOTE: A line filter is

required when water conditions have a high sediment content. Do

not use "self piercing'" valves. Saddle valve kit

(part #4-20-088-0) available from your distributor.

Route the water line up thru the floor within _12"from wall,

Figure 5

Route the water line thru the wall no more than 3" from floor when routed under unit. See Figure 6.

NOTE: Regardless of the routing, allow for at least 3 feet of excess copper tub- ing to remain outside wall or floor for easy connection to the unit.

Figure 6

UNPACKING

Step 5.

Uncrate unit, remove wood

base and die,card the shipping bolts which secure the wood

base to the bottom of the unit. Do not discard wood block and hardware to be used for blocking your unit.

Figure 4

no higher than 3" from floor when routed under unit. See

Figure 5.

In addition retract front

leveler legs to ensure easier movement of the unit for installation.

3