IV. OPERATION (continued)
IV. a - TEMPERATURE CONTROL: (continued)
F Colder
R
O
NTemperature
Adjustment
Shaft
T
V. CARE & MAINTENANCE
V. a - CLEANING THE CONDENSER/FILTER:
The most important thing you can do to insure a long, reliable service life for your Traulsen is to regularly clean the condenser coil and or filter.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE CLEANING ANY PARTS OF THE UNIT.
To clean the condenser/filter, first disconnect electrical power to the cabinet and remove the system side cover.
Proceed to vacuum or brush any dirt, lint or dust from the finned condenser coil/filter, the compressor and other cooling system parts. If significant dirt is clogging the condenser fins or filter, use compressed air to blow this clear.To replace the system side cover reverse the process.
V. b - REPLACING THE DOOR GASKETS:
To remove the gasket to be replaced, grasp it firmly by one corner and pull it out. Before attempting to install a new gasket, both the unit and the gasket itself must be at room temperature. Insert the four corners first by using a rubber mallet (or hammer with a block of wood). After the corners are properly inserted, work your way towards the center from both ends by gently hitting with a mallet until the gasket is completely seated in place (see figure below for proper gasket placement).
NOTE: The gasket may appear too large, but if it is installed as indicated above it will slip into place.
Front Door
Gasket
NOTE: System gasket attached with screw.
V. CARE & MAINTENANCE (continued)
V. b - REPLACING THE DOOR GASKETS:
Top Door
Gasket
V. c - CLEANING THE CABINET SURFACES:
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE CLEANING ANY PARTS OF THE UNIT.
Exterior stainless steel should be cleaned with warm wa- ter, mild soap and a soft cloth. Apply with a dampened cloth and wipe in the direction of the metal grain.
Avoid the use of strong detergents and gritty, abrasive cleaners as they may tend to mar and scratch the sur- face. Do NOT use cleansers containing chlorine, such as bleach, this may promote corrosion of the stainless steel.
Care should also be taken to avoid splashing the unit with water, containing chlorinated cleansers, when mopping the floor around the unit.
For stubborn odor or spills, use baking soda and water (mixed to a 1 tbsp baking soda to 1 pint water ratio).
A stainless steel polish is recommended for shining of unit.
The unit is equipped with a drain for cleaning the inside of the unit.