•Do not leave the door open any longer than necessary.
•Do not set temperature any colder than necessary.
•Put frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge.
Something Not Working
If the appliance is not functioning correctly, please carry out the following checks before contacting your local AEG Service Force Centre.
Warning!
Repairs should only be carried out by qualified service engineers. Repairs carried out by inexperienced persons may cause injury or serious malfunc- tioning.
Symptom |
| Possible Cause |
| Remedy |
|
|
|
|
|
Symptom |
| Possible Cause |
| Remedy |
|
|
|
|
|
The compressor does not start | This is normal, no error has | The compressor starts after a | ||
immediately after changing |
| occurred. |
| period of time. |
the temperature setting. |
|
|
|
|
|
|
|
|
|
Water on the floor or on sto- | Water drain hole is blocked. | See the "Cleaning and Care" | ||
rage shelves. |
|
|
| section. |
|
|
|
|
|
If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for any
Changing the light bulb
|
| Appliance is not switched on |
|
|
|
|
| Mains plug is not plugged in |
Appliance does not work. |
| or is loose. |
|
| |
| Fuse has blown or is defective. | |
|
| |
|
|
|
|
|
|
|
| Socket is defective. |
|
|
|
|
|
|
Appliance cools too much. |
| Temperature is set too cold. |
|
|
|
Switch on the appliance.
Insert mains plug.
Check fuse, replace if neces- sary.
Mains malfunctions are to be corrected by an electrician. Turn the temperature control knob to a warmer setting.
Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it. Light bulb data:
1. | To switch off the appliance, turn the |
| temperature control knob to position |
| "0". |
2. | Unplug the mains plug. |
3. | To change the light bulb, remove the |
Temperature is not properly adjusted.
Door was open for an exten- ded period.
The food is too warm. A large quantity of warm food was placed in the appliance within the last 24 hours.
The appliance is near a heat source.
Interior lighting does not work. Light bulb is defective.
Heavy build up of frost, possi- |
| Door seal is not air tight (pos- |
bly also on the door seal. |
| sibly after reversing the door). |
|
|
|
Please look in the "Initial Start Up" section.
Open the door only as long as necessary.
Turn the temperature control knob to a colder setting.
Please look in the "Installation location" section.
Please look in the "Changing the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand until it sits cor- rectly.
| screw from the light bulb cover. |
4. | Unhook the light bulb cover as |
| shown. |
5. | Change the defective light bulb. |
6. | Refit the light bulb cover and the |
| screw. |
7.Put the refrigerator back into opera- tion.
14
15