OPERATING INSTRUCTIONS
7
button again or adjusting the AUDIO CONTROL 2 level will return to the volume level setting in use before the Mute function was activated.
During disc play, pressing this button will mute disc audio and disc play will be paused. During this time, the 
indication will remain on the display panel to show that a disc is still loaded in the unit.
bl AM/FM BAND SELECTOR (BAND)
Each time this button is pressed, the radio band is changed. The indication AM, F1, F2 or F3 will appear on the display panel according to your selection.
bm UP/DOWN TUNE/SEEK/TRACK
( 
/ 
) BUTTONS
To manually select a radio station,
momentarily press the Up Tuning ( 
) button to tune the unit higher, or the Down
Tuning ( 
) button to tune lower within the selected band. The radio will automatically tune to the next strong station and stop on this frequency. If the LOCAL mode is in effect, the radio will seek the next local station and stop at that frequency.
Pressing either button for longer than 2 seconds will cause MANUAL to appear on the display, accompanied by a beep tone, thereby entering the seek mode. Pressing a button in this mode will cause the radio to rapidly tune in the up or down direction and stop when the button is released. The radio will then remain at that frequency. Five seconds after Manual tune is inactive, AUTO will momentarily appear for 2 seconds, thereby reverting to the normal tuning mode.
bn LOCAL BUTTON
This feature is used to select the strength of the signals at which the radio will stop during Manual Seek Tuning. Pressing and holding the button will select the Local setting (LOCAL will appear on the display panel for 5 seconds and LOC will remain in the lower left corner) and only strong (local) stations will be received. Pressing and holding the button again will select the Distant setting (Dx will appear on the display panel for 5 seconds) and the radio will stop at a wider range of signals, including weaker (more distant) stations.
bo FM MONO/STEREO BUTTON (MONO)
During FM radio operation, this button is used to select monaural or stereo reception of the broadcast signal. Under normal reception conditions, the unit should be left in the stereo mode as indicated by the ST indication on the display panel when tuned to an FM stereo signal. If the stereo signal is too noisy for comfortable listening, press the MONO button to switch to monaural reception (the ST indication will disappear from the display panel and MONO will appear). To return to stereo reception mode, press the button again so that the ST indication appears on the display panel.
bp
AUTO-STORE TUNING (AS)
Press this button momentarily to scan the stations
8 of 20