Front Side Panel, Connector for IR Blaster, Reset

FRONT SIDE PANEL

1. Connector for IR Blaster

The 3.5mm mini connector is for IR B l a s t e r O u t p u t . I R B l a s t e r s c a n b e hooked up to the connector.

2.Connector for Stereo Audio Pre-Out (Option)

The 3.5mm mini connector is for Stereo A u d i o P r e - O u t . T h e P r e - O u t i s f o r

connecting to external Stereo Audio systems and the latency between the P r e - O u t a n d V i d e o w i l l h a v e t o b e adjusted by time delay module. So, the Pre-Out is an option and will be installed f o r s p e c i a l d e s i g n e d p r o j e c t s a n d according to special orders only.

FRONT PANEL

1.LED 1 (Orange) Wireless LED Blinking slowly : wireless is connecting Blinking quickly : wireless is connected and transmitting data.

2.LED 2 (Green) Power LED

This is a Power On LED.

3.LED 3 (Red) Tuner Status Tuner Initialization Confirmed

4.RESET

This is a switch to reset TR1a. When TR1a experiences unstable operation or trouble for connecting,

you can use the switch to reset TR1a by following procedure,

a. Switch off the TR1a

b. Press and hold the reset button and then switch on TR1a

c. Wait for 5 seconds and then release the reset button.

d. the TR1a should have then been reset to factory default setup.