Whirlpool W10200946A Gas Supply Line, Gas Pressure Regulator, Burner Input Requirements

Page 6

Gas Supply Line

Provide a gas supply line of ¾" (1.9 cm) rigid pipe to the range location. A smaller size pipe on longer runs may result in insufficient gas supply. Pipe-joint compounds that resist the action of LP gas must be used. Do not use TEFLON®† tape. With LP gas, piping or tubing size can be ½" (1.3 cm) minimum. Usually, LP gas suppliers determine the size and materials used in the system.

Flexible metal appliance connector:

If local codes permit, a new CSA design-certified, 4 to 5 ft (122 to 152.4 cm) long, ½" (1.3 cm) or

¾" (1.9 cm) I.D., flexible metal appliance connector may be used for connecting range to the gas supply line.

Gas Pressure Regulator

The gas pressure regulator supplied with this range must be used. The inlet pressure to the regulator should be as follows for proper operation:

Natural gas:

Minimum pressure: 5" WCP

Maximum pressure: 14" WCP

LP gas:

Minimum pressure: 11" WCP

Maximum pressure: 14" WCP

Contact local gas supplier if you are not sure about the inlet pressure.

A ½" (1.3 cm) male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator.

Do not kink or damage the flexible metal tubing when moving the range.

Rigid pipe connection:

The rigid pipe connection requires a combination of pipe fittings to obtain an in-line connection to the range. The rigid pipe must be level with the range connection. All strains must be removed from the supply and fuel lines so range will be level and in line.

Must include a shutoff valve:

The supply line must be equipped with a manual shutoff valve. This valve should be located in the same room but external to the range. It should be in a location that allows ease of opening and closing. Do not block access to shutoff valve. The valve is for turning on or shutting off gas to the range.

B

A

C

A. Gas supply line

B. Shutoff valve “open” position

C. To range

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

Burner Input Requirements

Input ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m).

For elevations above 2,000 ft (609.6 m), ratings are reduced at a rate of 4% for each 1,000 ft (304.8 m) above sea level (not applicable for Canada).

Gas Supply Pressure Testing

Gas supply pressure for testing regulator must be at least

1" water column pressure above the manifold pressure shown on the model/serial rating plate.

Line pressure testing above ½ psi gauge (14" WCP)

The range and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½ psi (3.5 kPa).

Line pressure testing at ½ psi gauge (14" WCP) or lower

The range must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi (3.5 kPa).

6

Image 6
Contents Instructions D’INSTALLATION DES Cuisinières À GAZ Autoportantes DE 30 76,0 CMRange Safety Your safety and the safety of others are very importantInstallation Requirements Tools and PartsLocation Requirements Cabinet Dimensions Mobile Home Additional Installation RequirementsProduct Dimensions Mobile home installations requireType of Gas Electrical RequirementsGas Supply Requirements Natural gasGas Pressure Regulator Gas Supply Pressure TestingGas Supply Line Burner Input RequirementsInstallation Instructions Install Anti-Tip BracketUnpack Range Make Gas Connection Typical rigid pipe connectionTypical flexible connection Verify Anti-Tip Bracket Location Level RangeComplete Connection Electronic Ignition System Initial lighting and gas flame adjustmentsIf the low flame needs adjusting Check Operation of Cooktop BurnersIf you need Assistance or Service Complete InstallationIf the flame needs adjusting If range does not operate, check the followingGAS Conversions LP Gas ConversionTo Convert Gas Pressure Regulator Complete Conversion To Convert Surface BurnersTo Convert Oven Burner Natural Gas Conversion Natural gas oven orifice spud stamped with Sécurité DE LA Cuisinière Votre sécurité et celle des autres est très importanteAvertissement Exigences D’INSTALLATION Exigences demplacementOutillage et composants Dimensions du produit Dimensions des placardsType de gaz Spécifications électriquesSpécifications de l’alimentation en gaz Gaz naturelDébit thermique des brûleurs Canalisation de gazDétendeur de gaz Tests de pressurisation de la canalisation de gazInstructions D’INSTALLATION Installation de la bride antibasculementDéballage de la cuisinière Raccordement au gaz Raccordement typique à une canalisation rigideRaccordement typique par raccord flexible Compléter le raccordementSystème dallumage électronique Vérification de lemplacement de la bride AntibasculementRéglage de laplomb de la cuisinière Allumage initial et réglages des flammes de gazSi la flamme basse doit être réglée Achever l’installation Si vous avez besoin dassistance ou de serviceSi la cuisinière ne fonctionne pas, contrôler ce qui suit Conversions Pour Changement DE GAZ Conversion pour lalimentation au propaneConversion du détendeur Conversion des brûleurs de surface Terminer la conversion Conversion pour lalimentation au gaz NaturelConversion du brûleur du four Conversion des brûleurs de surface W10200946A

W10200946A specifications

The Whirlpool W10200946A is an innovative and versatile kitchen appliance that stands out for its impressive array of features and technologies designed to enhance culinary experiences. This dishwasher offers a perfect blend of convenience, efficiency, and performance, making it an essential addition to any modern kitchen.

One of the main features of the W10200946A is its advanced cleaning technology. This model utilizes a powerful wash system that ensures dishes come out sparkling clean every time. With multiple wash cycles available, users can select the perfect setting for any load, from heavily soiled pots and pans to delicate glassware. The Sensor Cycle option automatically detects the level of soil on the dishes and adjusts the wash and rinse settings accordingly, optimizing water and energy usage while providing a thorough cleaning.

In terms of capacity, the W10200946A does not disappoint. It boasts a spacious interior that can accommodate up to 13 place settings, making it ideal for families or those who frequently entertain guests. The model features adjustable upper racks, allowing users to customize the interior space to fit taller items and bulky cookware.

Energy efficiency is another hallmark of this dishwasher. It is designed to operate on low water consumption, making it an eco-friendly choice that can help reduce utility bills. The ENERGY STAR certification reflects its commitment to environmental sustainability without sacrificing performance.

Moreover, the W10200946A incorporates a Quiet Wash sound insulation system, ensuring that the dishwasher operates at an exceptionally low noise level. This feature is particularly beneficial for open-concept living spaces where peace and quiet are essential.

Ease of use is prioritized with the user-friendly control panel, which is intuitive and straightforward. The delayed start option allows users to set the machine to run at a more convenient time, while the time remaining display provides at-a-glance updates on cycle progress.

In conclusion, the Whirlpool W10200946A is an exemplary dishwasher that combines cutting-edge technology with practical features. Its powerful cleaning capabilities, spacious design, energy efficiency, and quiet operation make it a valuable addition to any household. Whether you are looking to upgrade your current dishwasher or install a new one, the W10200946A stands out as a reliable and efficient choice.