Whirlpool TGS325MQ3 Aluminum Foil, Bakeware, Meat Thermometer, Oven Vent, Baking and Roasting

NUMBER OF	POSITION ON RACK
PAN(S)
3 or 4	Opposite corners on each rack. Make sure
	that no bakeware piece is directly over
	another.

Aluminum Foil

IMPORTANT: Do not line the oven bottom with any type of foil, liners or cookware because permanent damage will occur to the oven bottom finish.

■On those models with bottom vents, do not block or cover the oven bottom vents.

■Do not cover entire rack with foil because air must be able to move freely for best cooking results.

■To catch spills, place foil on rack below dish. Make sure foil is at least ¹⁄₂" (1.3 cm) larger than the dish and that it is turned up at the edges.

Bakeware

The bakeware material affects cooking results. Follow manufacturer’s recommendations and use the bakeware size recommended in the recipe. Use the following chart as a guide.

BAKEWARE/RESULTS		RECOMMENDATIONS
Light colored aluminum		■ Use temperature and time
■	Light golden crusts	recommended in recipe.
■	Even browning
Dark aluminum and other		■ May need to reduce baking
bakeware with dark, dull		temperatures 25°F (15°C).
and/or nonstick finish		■ Use suggested baking time.

■Brown, crisp crusts

■For pies, breads and casseroles, use temperature recommended in recipe.

■Place rack in center of oven.

Insulated cookie sheets		■ Place in the bottom third of
or baking pans		oven.
■ Little or no bottom		■ May need to increase baking
	browning	time.
Stainless steel		■ May need to increase baking
■	Light, golden crusts	time.
■	Uneven browning
Stoneware/Baking stone		■ Follow manufacturer’s
■	Crisp crusts	instructions.
Ovenproof glassware,		■ May need to reduce baking
ceramic glass or ceramic		temperatures 25°F (15°C).
■	Brown, crisp crusts

Meat Thermometer

On models without a temperature probe, use a meat thermometer to determine doneness of meat, poultry and fish. The internal temperature, not appearance, should be used to determine doneness. A meat thermometer is not supplied with this appliance.

■Insert the thermometer into the center of the thickest portion of the meat or inner thigh or breast of poultry. The tip of the thermometer should not touch fat, bone or gristle.

■After reading the thermometer once, push it into the meat ½" (1.3 cm) more and read again. If the temperature drops, cook the meat or poultry longer.

■Check all meat, poultry and fish in 2 or 3 different places.

Oven Vent

A

A. Oven vent

The oven vent releases hot air and moisture from the oven, and should not be blocked or covered. Blocking or covering the oven vent will cause poor air circulation, affecting cooking and cleaning results. Do not set plastics, paper or other items that could melt or burn near the oven vent.

Baking and Roasting

IMPORTANT: Do not place food or cookware directly on the oven door or the oven bottom.

Before baking and roasting, position racks according to the “Positioning Racks and Bakeware” section.

To Bake or Roast:

1.Touch BAKE.

Touch TEMP “up” or “down” arrow pads to set a temperature other than 350°F (177°C) in 5°F (3°C) amounts. The bake range can be set between 170°F and 500°F (77°C and 260°C).

2.Touch START/ENTER.

The temperature can be changed at any time after this step by touching the TEMP/TIME “up” or “down” arrow pads. START/ENTER does not need to be touched again. If baking/ roasting while the Timer is counting down, the set baking/ roasting temperature can be displayed for 5 seconds by touching BAKE.

3.Touch OFF/CANCEL when finished.

Preheating

After START/ENTER is touched, the oven will enter a timed preheat conditioning cycle. The Temp, Bake, and On indicator lights will light up. The Electronic Oven Control automatically selects the conditioning cycle time based on the oven temperature selected. The conditioning cycle time will not change if the temperature is reset before the cycle countdown ends. The preheat conditioning cycle is complete and the oven is ready to use when a 1-second tone sounds, the cycle countdown ends, and the set temperature is displayed.

Preheat temperatures are affected by varying factors such as room temperature and peak energy usage times. It is normal for the temperature showing on the display and the actual oven temperature to differ.

Waiting an additional 10 minutes after the preheat conditioning time ends to put food in the oven is suggested when baking foods with leavening ingredients, such as yeast, baking powder, baking soda and eggs.

9