Whirlpool SF367LEMB0 Display, Start, CancelorOff/Cancel, Clock, Tones, Fahrenheit and Celsius

Style 2 Electronic Oven Controls (on some models)

1 2 3 4 5 6

	11	10	9	8	7
1.	Oven Display				7.	Temperature/Time
2.	Clock				8.	Cook Time
3.	Timer/Cancel				9.	Start Time
4.	Start/Enter				10.	Custom Broil
	(Control Lock)				11.	Bake

5.Auto Clean

6.Off/Cancel

Display

When power is first supplied to the appliance, “PF” will appear on the display. Press CANCEL or OFF/CANCEL to clear “PF” from the display.

If “PF” appears at any other time, a power failure has occurred. Press CANCEL or OFF/CANCEL and reset the Clock if needed.

When the oven is not in use, the display shows the time of day.

When performing a timed cook function, the display will show either hours and minutes, or minutes and seconds.

Start

The START or START/ENTER pad begins any oven function. If not pressed within 5 seconds after pressing a function pad, the “START?” indicator light will flash as a reminder. On some models, “START?” will appear on the display.

If not pressed within 5 minutes after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled.

CancelorOff/Cancel

The CANCEL or OFF/CANCEL pad stops any function except the Clock, Timer and Control Lock.

Clock

On some models, this is a 12-hour clock that shows a.m. and p.m.

To Set:

Before setting, make sure the oven and Timer are off.

1.Press CLOCK.

2.Depending on your model, press the HR or MIN or TEMP/ TIME “up” or “down” arrow pads to set the time of day. Only on some models can the time be set to include a.m. or p.m.

3.Press CLOCK or START.

Tones

Tones are audible signals, indicating the following:

One tone

■Valid pad press

■Oven is preheated (long tone)

■Function has been entered

■Reminder (on some models), repeating each minute after the end-of-cycle tones

Three tones

■Invalid pad press

Four tones

■End of cycle

Reminder Tones (on some models): Reminder tones may be turned off. Press and hold STOP TIME for 5 seconds. “rEP OFF” or “off” will appear in the display. Repeat to turn reminder tones back on, and “rEP on” or “on” will appear in the display.

All Tones: All of the above tones are preset on. All except the end-of-cycle tones can be turned off.

To Turn Off/On (on some models): Press and hold START TIME for 5 seconds. A tone will sound and “Snd OFF” will appear on the display. Repeat to turn tones on, and “Snd on” will appear on the display.

On some models, only the loudness of the tones can be adjusted. On other models, the tones cannot be adjusted or turned off.

Tone Pitch: The pitch is preset at high, but can be changed to low. On some models, only the loudness of the tones can be adjusted. On other models, the tones cannot be adjusted or turned off.

To Change (on some models): Press and hold BAKE for 5 seconds. A tone will sound, and “Snd LO” will appear on the display. Repeat to change, and “Snd Hi” will appear on display.

Fahrenheit and Celsius

The temperature is preset at Fahrenheit, but can be changed to Celsius on some models.

To Change: Press and hold CUSTOM BROIL for 5 seconds. A tone will sound, and “°C” will appear on the display. Repeat to change back to Fahrenheit. To exit mode, press CANCEL.

Timer

The Timer can be set in hours or minutes up to 12 hours and 59 minutes, and counts down the set time. The Timer does not start or stop the oven.

To Set:

1.Press TIMER SET or TIMER* CANCEL. The timer indicator light will light up on some models. If no action is taken after 5 minutes, the display will return to the time of day mode.

2.Depending on your model, press the HR or MIN or TEMP/ TIME “up” or “down” arrow pads to set the length of time to cook.

3.Press START or TIMER SET. When the set time ends, end-of- cycle tones will sound, then, if enabled, reminder tones will sound every minute on some models.

8