Cornelius Series 725, Series 525, Series 200 manual

Self-Contained Flaked Ice Maker Service Manual

	D. ”O” ring leaking at bottom of	D. Check and replace ”O” ring
	evaporator shell
	E. Compressor not running	E. Check and replace ”O” ring

Water leaks.	A. Worn or bad float valve	A. Check and replace
	B. Float and arm assembly stuck	B. Check and replace
	C. ”O” ring leaking at bottom of	C. Check and replace
	evaporator shell
	D. Storage bin drain and tubing	D. Check and repair

Excessive noise or	A. Mineral or scale deposits on	A. Remove and clean inside
chattering.	inside of evaporator shell	surfaces by immersing
		evaporator shell in ice machine
		cleaner
	B. Intermittent water supply	B. Check inlet water line
	C. Water level in float tank too low	C. Check and adjust water
		level
	D. Auger gearmotor end-play or	D. Repair or replace
	worn bearings
	E. Air lock in gravity water supply	E. Check and adjust warmer
	line from float tank to evaporator
	shell

Machine runs with full bin	A. Storage bin thermostat set too	A. Check and adjust warmer
of ice.	cold
	B. Bin thermostat thermowell out	B. Adjust thermowell
	of path of ice

Unit off on reset.	A. Ice jams up in evaporator shell	A. Clean inside surface of
		evaporator shell
	B. Bin thermostat will not shut-off	B. Check and adjust or replace
	machine. Set too cold.
	C. Auger motor has worn	C. Check and replace
	bearings

Unit goes off on reset.	A. Ice chute out of alignment,	A. Re-align
	restricted ice flow out of
	evaporator section
	B. Ice chute center separator bent	B. Replace ice chute
	restricting ice flow out of
	evaporator section

C. Incoming water temperature too cold

D. Bin thermostat does not shut- off when bin is full of ice

E. Mineral or scale deposits on inside of evaporator shell and evaporator

F. Strips loose or missing on inside of evaporator shell

C. Maintain temperature above 50°F

D. Replace bin thermostat if necessary

E. Inspect and clean

F. Inspect and replace evaporator shell if necessary

Publication Number: 166240010SER

- 16 -