Electrolux - Gibson Top Freezer Frost Clear Refrigerator manual Refrigerator Door

Freezer Door

6. To remove freezer handle: Reverse handles

while doors are off. Remove the two screws attaching the handle to the bottom of the freezer door. Swing

To reattach trim: Slide both trim locks out of trim. Insert the new adhesive trim locks contained in your literature pack. NOTE: Trim lock must be removed and installed by sliding OVER the two donut shaped areas. Install trim to handle by sliding under base of handle. Carefully align trim and press down at trim lock locations. Replace hole plug on opposite side. Use rubbing alcohol to remove any adhesive residue from old trim lock location(s).

bottom of handle away from the door

and slide handle straight up and off

of dovetail button. Remove screw and

dovetail button and install on other side, using the same holes as the nameplate. To move nameplate to other side, remove the magnetic nameplate from its frame, turn frame upside down and install in old handle holes. Insert magnetic nameplate into frame. Reverse instructions for reattaching handle. Start with handle offset away from the door. Place top of handle over dovetail button, swing handle into an upright position and push upward, locking it into place. Secure bottom of handle with screws.

7. To remove	Refrigerator Door
refrigerator

8.Remove door stop from bottom of freezer and refrigerator door and reinstall on opposite side.

Freezer Door

Refrigerator Door

handle: Remove the

two screws attaching

the handle to the top

of the refrigerator

door. Swing the top

of handle away

from the door and

slide handle down

and off of dovetail

button. Remove

screw and dovetail

button and install on

other side moving

hole plugs from

corresponding holes

to the opposite side.

Reverse instructions

for reattaching

handle. Start with

handle offset away

from the door. Place

bottom of handle

over dovetail button,swing handle into an upright position and push downward, locking it into place. Secure top of handle with screws.

Trim Removal (Full-Length Trim models only)

In some models, the refrigerator door has a full length trim piece which continues from the bottom of the handle to the bottom of the door. The top of the trim fits around the base of the handle. An adhesive "trim lock" is positioned about halfway down. The bottom of the trim is held in place by either an adhesive trim lock, or a trim lock with two prongs inserted into a hole on the face of the door. Remove the trim by gently pulling the trim lock areas out and away from the door. When the trim is free from the door, gently pull the trim down and away from the base of the handle.

9. If your
refrigerator does
not have a Toe
Grille, use a putty
knife to remove
the plastic plug
(not shown) from
front of base and
reinstall in the
opposite set of
lower hinge holes.	or
Assemble lower
hinge to cabinet.
Install hinge pin in
opposite hinge
hole from which it
was removed.
Install the washer
(some models) on
the lower hinge
pin and insert
hinge screws, but

do not tighten. Hinges will have to remain loose against cabinet to align door.

10.Turn center hinge upside down and secure to cabinet as shown, using the screws

which are in the new holes. Install refrigerator door on lower hinge pin. Align door with edge of cabinet. Hold the door on front of cabinet.

11