Gaggenau AH 600-190 manual Important Before marking the securing holes

15	Proceed as follows:
	Important: Before marking the securing holes,
	make sure that no electricity or water lines or
300	other lines are laid at the drilling points in the wall.
	Exhaust air operation:
310	– From the bottom edge of the hood, mark a center
230	line on the wall.
	– With the aid of the drilling template, mark the
270	positions of the screws on the wall. Mark the
448	contour of the hook-in area. This will make it
137	easier to hook in the hood (Fig. 18).
625
min. 600 electric	– Pay attention to the minimum clearance of 600 mm
min. 670 gas	for electric cookers and 670 mm for gas cookers.
	The bottom edge of the template corresponds to
	the bottom from edge of the hood.
Fig. 18	– Using the drilling template, drill the 6 holes for
	the hood (area I of the drilling template) and the
	two holes for suspending the chimney (area II of
	the drilling template). In the top two securing
	holes for the hood, fix the two hooks e with the
	countersunk screws d. Make sure that the hooks
	lie flatly on the wall. In certain circumstances you
	may have to countersink the drill holes. Fit the
	included dowels a in the other drill holes.
	Note: Pay attention to any special accessories that
	you may have to fit.
	– Screw on the retaining bracket for the chimney
	paneling.
	– Detach the grease filters.
	– Unscrew the two black plates on the left and right
	of the chimney.
	– Hang the hood on the two hooks. Adjust the
	suspended element with the recessed head
	screw and align the hood using a spirit level
	(Fig. 19).
Fig. 19
14