Short form specifications

PROJECT

ITEM #

QUANTITYDATE

APPROVAL

MFSC

Built-in self contained milk or beverage dispensers

The exterior sides and top edge shall be 20-gauge galvanized steel.

Exterior bottom to be 14-gauge galvanized steel.

Inner liner shall be water tight and constructed of 22-gauge stainless steel with a 1.25” (3.2cm) I.P.S. drain. Opening(s) shall have throat liners constructed of high impact plastic. Unit to be insulated with foamed-in-place polyurethane insulation with a non- conductive breaker strip.

Each opening shall have an insulated, stainless steel folding lid with high impact plastic liner, molded rubber edge and black plastic handles.

(1) stainless steel louver shall be provided for installation in the cabinet to allow proper airflow to the condensing unit.

Each self-leveling mechanism shall be field adjustable by adding or removing stainless steel extension springs in the elevator housing inside the unit. The elevators shall be connected by removable platform carriers constructed of 18-gauge stainless steel.

Model MFSC-31

Refrigeration system shall use HFC-134a refrigerant. Refrigerant flow shall be controlled by an expansion value. Cabinet shall maintain 36°F to 40°F (2°C to 4°C) temperature with lids closed for storage. Refrigeration system shall be controlled by a pressure control, located near the condensing unit.

Electrical connections shall be 115 volt, 60 cycle, and single phase. Unit shall have a 9’ (2.7m) long electrical cord and NEMA 5-15P installed at the mechanical end.

THE FOLLOWING APPLIES TO MODELS MFSC-2821,

MFSC-31, MFSC-44 AND MFSC-57 ONLY:

(6)anodized aluminum divider trays will be supplied per opening. NOTE: See chart on back for milk storage capacity.

Optional Accessories & Modifications

•Lid locking device

•Wire baskets (not available on MFSC-2020)

•Lexan® covers

•Special voltages (contact factory)

The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com