Installation Clearance Requirements

*This icemaker should be installed by a licensed plumber only.

*To ensure proper service access and ventilation, allow more 4” clearance at rear, and 1/2” at top and 1/2” at sides. The installation should allow the icemaker to be pulled forward for servicing if necessary.

*When installing the ice maker under a counter, follow the recommended spacing dimensions shown. Place electrical and water supplies and drain fixtures in the recommended locations as shown.

*Choose a well ventilated area with temperatures above 55°F and below 90°F.This unit MUST be installed in an area protected from the elements, e.g., wind, rain, water spray or drips.

*The icemaker should not be located next to ovens, grills or other high heat resources.

*The ice maker requires a continuous water supply with a minimum pressure of 0.05Mpa and a static pressure not to exceed 0.8Mpa. The temperature of the water feeding into the ice maker should be between 41°F and 77°F for proper operation. The ambient operational temperature should be between 55°F and 90°F. Operation outside these temperatures may result in lowered production or other adverse effects.

	4”
	Top of Unit
1/2”	1/2”

4”

1/2”

Water Line

Floor Drain

•The unit should be located on a firm and level surface. It is important for the ice maker to be level in order to work properly. If needed, you can adjust the height of the ice maker by rotating the feet. See the “Leveling the Ice Maker” section.

•A standard electrical supply (115 VAC only, 60 Hz, 15 A), properly grounded in accordance with National Electrical Code and local codes and ordinances is required.

•IMPORTANT: Do not kink or pinch the power supply cord between the ice maker and wall or cabinet.

EdgeStar Full Size Ice Maker