500 Series Display Cases Service and Installation Manual
CONTENTS |
|
RECEIVING & INSPECTING EQUIPMENT | 2 |
SPECIFICATIONS | 3 |
PRESSURE CONTROL SETTINGS | 5 |
INSTALLATION | 5, 6 |
OPERATION | 5, 6 |
CARE & CLEANING | 6 |
WIRING DIAGRAMS |
|
7 | |
7 | |
8 | |
8 | |
EXPLODED VIEWS & PARTS LISTS |
|
9 | |
9 | |
10 | |
10 | |
11 | |
11 | |
12 | |
12 | |
13 | |
13 | |
14 | |
14 | |
FLUORESCENT LIGHT ASSEMBLY | 15 |
DOOR ASSEMBLY | 16 |
REFRIGERATION ASSEMBLES | 17 |
FOOD WELL ASSEMBLY | 18 |
REPLACEMENT PARTS LIST | 19 |
STANDARD LABOR GUIDELINES | 20 |
STANDARD WARRANTIES | |
AUTHORIZED PARTS DEPOTS | back cover |
SERIAL NUMBER LOCATION
The Serial number on all 500 Series units is located on the rear of the unit, near the ON/OFF switch.
Always have the serial number of your unit available when calling for parts or service. A complete list of authorized Delfield parts depots is shown on the back cover of this manual.
©2003 The Delfield Company. All rights reserved. Reproduction without written permission is prohibited. “Delfield” is a registered trademark of The Delfield Company.
RECEIVING AND INSPECTING THE EQUIPMENT
Even though most equipment is shipped crated, care should be taken during unloading so the equipment is not damaged while being moved into the building.
1.Visually inspect the exterior of the package and skid or container. Any damage should be noted and reported to the delivering carrier immediately.
2.If damaged, open and inspect the contents with the carrier.
3.In the event that the exterior is not damaged, yet upon opening, there is concealed damage to the equipment notify the carrier. Notification should be made verbally as well as in written form.
4.Request an inspection by the shipping company of the damaged equipment. This should be done within 10 days from receipt of the equipment.
5.Check the lower portion of the unit to be sure adjustable feet are not bent.
6.Also open the compressor compartment housing and visually inspect the refrigeration package. Be sure lines are secure and base is still intact.
7.Freight carriers can supply the necessary damage forms upon request.
8.Retain all crating material until an inspection has been made or waived.
Uncrating the Equipment
First cut and remove the banding from around the crate. Remove the front of the crate material, use of some tools will be required. If the unit is on legs remove the top of the crate as well and lift the unit off the skid.
2For customer service, call (800)